Show off your Sak mod's!
-
I wouldn't kick that out of bed for eating biscuits! :D
-
@PTRSAK said:
Temporary build of a Neo-Voyageur. Pinned with salvaged center pins from 91mm teardowns.Need to stop in and pick up a scissor spring tomorrow.

I wanted to build this up to get a feel for what it would be like. If I like carrying it I will continue on in my efforts to pick up a ribbed cadet.
I... LIKE... THAT.

-
@crackout said:
I also tried to use replacement springs from 91mm models on my vintage 84mm scissors and had no luck. The cureld up part is too big to fit into the hole and the overall spring is too long preventing the scissors from fully closing. I ended up writing Victorinox and they sent me 3 84mm springs. :D Not sure if these were remaining stock from the old days or springs for Executives. But they're definitely neither 58mm nor 91mm.Here's a comparison shot:

58mm spring, 84(?)mm spring, 91mm spring
I've converted the 91mm springs to 84mm in the past. It's doable, not easy, but doable. I know Neil has some 84mm springs in stock but he isn't around as much anymore. :(
Here's a pic of a 91mm spring in 84mm scissors.

-
Ya it looks like youd have to grind a bit of the curled part off, then it could be compressed to fit.
-
That won't do it. You'd have to cut more and then recurl the end.
-
Ah, those suckers are hard to bend too.
-
Try heating the end of the spring up red hot with a butane pencil torch and letting it cool naturally, should be at least semi annealed and be easier to bend. then heating again and quenching will harden it again. The only problem is if it is too brittle and needs tempering as well.
A useful trick is to hold the spring in a tub of water with just the part you want to heat up sticking out, then the heat treatment of the rest of it is not effected. I used this trick to soften the tang of some 91mm scissors to drill the pivot hole for 84mm conversion and then re-harden them.
It may be heat treatment at its crudest, but it works well enough for this, but probably too crude for blades.
-
A Prince in black Micarta

Unfortunately I had to rework the main blade too. Someone from the honing staff at Victorinox had produced a kind of dent in the edge (and this is not the first time I encountered this with factory new knives from Vic). I had to even it out, regrind the blade and set a new bevel. But now it is very sharp, the hairs flying off the arm voluntarily.
-
I put Danish Green scales on the Grøn Woody Yeoman 8)

-
Nice Rahmed!

-
my mod
-
Might make some out of non toxic wood

-
Nice mod! The only thing I might have done differently is replace that philips opposite of the mag glass because there is a bit driver already. Then again I'm not sure what I would replace the philips with, maybe get a wenger universal wrench in there somehow.
-
8 Hours with a jewelry saw. I must of went through 30 blades. I don't have a sander or grinder. I used files and sandpaper. That was too much work.





-
Cyber Yeoman.

-
-
Yep, and with ones made of 0.025 brass that sliver is barely 1/2 a mm wide.

Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
