Suspension plier assembly question
-
I don't know the history of MT development to answer this question, and I'm hoping someone here will know.
The plier head on the Suspension uses a metal bracket as the backstop for the pliers. It's held in place at the handle pivot, and with two additional screws. There are now a jillion tools to use this design, which seems to be an inexpensive solution to allowing tools with outside access.
Here's the question: Is the Suspension the first tool to use that plier backstop design?
-
Is that like the one on the Swisstool Spirit?
-
It's a bit similar, except it uses torx screws to secure it, instead of the metal of the scales wrapped around it, the way the Spirit works. Should I be asking when the Spirit came out?
EDIT: a look on the SAKWiki says the Spirit came out in 2004, but I THINK the design might have been on on the Swisstool as far back as '97/98. Still looking for when the Suspension was released.
-
In further searching, it seems this design was inherited from the Gerber Legend.
Can anyone confirm?
-
I think we might need Bob's input on this one.
-
Legend came out in 2000 I think so still could be the swisstool

Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
