The Apocalypse
-
can opener solves that.
-
Thanks. I am sending one off to my knife maker to see if he can match the vic one.
Next build.
-

Stonewashing Implements complete.
Now the wait for parts.
-
Cool, that looks quite nice. Is it as simple as it sounds, as shaking the parts in a jug with stones?
-
Radio shack etching acid and a tumbler with ceramic media from harbor freight. acid 50/50 mix and soak for 30 minutes. tumble for 45 min. Done.
-
And after breaking off a fin in the dryer and getting spanked by wife, I had ti get fancy with the tumbler. The tumbler also gives more consistency.
-
LOL, cool. Another thing I'd like to experiment with sometime.
-
This thread gets better each time I look

-
Now waiting on parts.
In the meantime, I decided to give my work SAK a new look. Let's just say I am pleased with the result.

-
NICE JOB, looks great, good combo of tools! JR
-
I like that Rick!¡!
-
That's awesome Rick...
I may try that. Did you do something to protect the edges and the pivot holes?Sent from my GT-S5830i using Tapatalk 2
-
No. No protection. The scissors retained their edge but you will need to bring edge back on knife. Spent an hour on sharp maker between diamond to ultrafine then strop.
-
this is looking very interesting.

-
Did you do the springs also?
Sent from my GT-S5830i using Tapatalk 2
-
My number one want is a solo in that green.
The Stone wash looks awesome.Does it affect the pivot of the tools though, the smoothness and the snap, especially on the scissors? I expect not but I am still interested.
-
@396988 said:
My number one want is a solo in that green.
The Stone wash looks awesome.Does it affect the pivot of the tools though, the smoothness and the snap, especially on the scissors? I expect not but I am still interested.
No. I don't think he pictured it here, but when he acid etched the blade it was protected with nail polish. The acid will eat into the steel if not protected.
-
I'll use nail polish if I want to create and pattern on the blade such as in this photo

or on this tool

On my first attempt for my project I did worry about the pivots and contact ateas so I did protect them. I did not like the look so I sacrificed my work sak parts and did them bare. Very pleased wirh result. Very little loss in snap if at all.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
