Carbidize!
-
how difficult is this? or is there already a guide around here.
off to search now.
-
You can't just post this without saying more!

-
this was the only hit on this forum for "Carbidize"
I tried
-
You'll need a carbidizer.
It's basically a controlled electrode you attach a bit of carbide to, then it spins. A current runs thru it and you hook up the other end of the circuit to your work piece.
The current deposits a small layer (I mean like microscopic) of carbide which is one of the hardest wearing metals on the work piece. Syph has one and I've been meaning to get one, I have a lot of broken carbide end mills/bits.
-
Yup its a handy way to use up broken end mills.
I use mine mostly for pivot areas on Titanium parts so they slide smoothly.

-
So, this would help Vic's slippery drivers?
-
I've seen a lot of vic drivers that have been stripped because they slipped out of a screw. Luckily I haven't done it but this could be a good solution.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login