Charge tti pivot screw specs/source
-
I have tried to get an answer for this for a long time, so I am really grateful that you bring this up. I don't need longer screws, i just want something not tampering resistant, and possibly brass or coated steel. I also wonder if pivots with lubrication grooves is just a gimmick or actually helpful (i saw this at a knife making site)?
-
The screws are a unified size and are about 3.45mm in diameter, probably a 6-40 UNF.
The actual pivots are a completely different matter however.
The plier end pivots are 5.60mm in diameter and 16mm in length.
The internal tool end pivots are 4.73mm in diameter and 16mm in length, however this pivot pin has two flat machined into it's shaft in opposite sites which give a flat to flat measurement of 4.47mm. This is part of the Charge's anti-clumping system as the handle casings and spacers between the tools have a correspondingly shaped hole and since they can't rotate the tool next to the one extracted is not disturbed.
So some of the pins would have to be custom made to fit.Lubrication grooves would cause problems for most multitools as unlike a knife which is mostly one big lump of metal with a hole in it and large, solid washers either side, a multitool will have a number of different, relatively narrow tools and, in the case of the Leathermans, 0.1mm washers between each, which are thin enough to drop into the lubrication grooves and cause operational stiffness, jamming and damage to the washers themselves.
-
So what I'm doing is taking off the saw's scale, putting a Kingston se9 jump drive with a bushing on the saws post, then putting a pointed tear drop "washer" on the end post capable to break glass then my house, mail, and car key. Haven't decided to put the scale back on or not. To finish this I need long post screws or posts, screws being easier to come by. Ideally I would have a wide head post screw such as on the surge' pliers at both ends but I'm not sure anyone will part with those.
Thanks for the info I will try to find some 6-40unf's.
-
@wes_robinson said:
then my house, mail, and car key.That might not be such a good idea. Most car ignition locks aren't designed to cope with heavy weights (eg a large multitool) hanging off them - they can wear out prematurely and cause all sorts of trouble (and thanks to
Murphy'sKirky's Law it will happen at a most inconvenient time). On some vehicles it will also be expensive and time consuming to fix (especially if your car has a built-in immobilizer). -
It's only used to open the door/trunk. I keep a key in the car. I also thought about some sort of spring clip to hold the tool up in the on position but abandon this idea, at least for now.
-
Thanks for the info Tofty! Helpful as always!
-
Actually a member from Germany is currently making a DLC coated Rebar (same size pivots) and is making his own pivot screws for it.
</topic/48949
-
The proto, put the car key on a snap, still needs a lot of fine tuning and longer screw for the key end and a longer and wider head for the saw jump drive end, no where ready for edc.

Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login