Knife re-handling project.
-
I've got a blonde you can have.
-
Bringing it back slightly ontopic (only slightly mind) What can i do with the little offcuts from the handles? Got a couple of bits 140x10x10mm and one bit 50x15x10mm any ideas anyone, seems a waste to just throw then out

-
unless you have special tools and skills not much I can think of to do with them,
to small for most things and being small, pretty dangerous to carve/work with reg
tools (like dowel pins or inlay), but I also hated wasting any wood. -
Thought as much :D
-
Well got a lot of uni work done this morning so this afternoon i got around to epoxying the liners to the handle blanks :) Also got the pins cut, so next job will be to drill some holes eek!


-
I thought you glued one scale to the tang "first" then drilled the pin holes?
my understanding was the pins are not to hold the scales down (the glue does)
but to keep them (scales) from lateral movement and support. -
Well i was planning on drilling one side, using the blade as a template. Then glue that side to the tang, then drill the other side using the other side and tang as a template
And yeah the pins are just to provide support :) -
-
@micky d said:
Well i was planning on drilling one side, using the blade as a template. Then glue that side to the tang, then drill the other side using the other side and tang as a template
And yeah the pins are just to provide support :)Sounds like a good plan mate, thats exactly what I'd do :)
Cool 8) Do need to remember to make the end of the scales that's near the blade is done up nicely before i stick them on though, as it will be hard to get at later (or so i've read....does make sense though :) )
-
@micky d said:
Well i was planning on drilling one side, using the blade as a template. Then glue that side to the tang, then drill the other side using the other side and tang as a template
And yeah the pins are just to provide support :)Sounds like a good plan mate, thats exactly what I'd do :)
Hang on, if that's what Mike would do, it's probably best to try something else. :D
-
Ben, sod off

Ryan, your bang on the money mate :)
-
YES! Definately finish the edge closest to the tang before glueing up!! Rough the glueing surfaces up well and wipe with acetone before doing the deed. I find 120 grit paper leaves a good etch on liner material.
Looking good! The black liners will be nice.
-
Thanks for the advice, much appreciated :) Will nail polish remover work instead of pure acetone?
-
Also what would be a good way of preparing the tang so the epoxy will stick better

Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login