Little Boy and Fat Man
-
According to a little bit of Googling, propane tanks (which is what I'm guessing you've got there) of about that size are rated to about 250psi assuming its in good condition. At 17 bar the boiling point of water is 200C.
Now it's been a few years since I did steam at uni and I wasn't really paying much attention then anyway, but that's a big bang with lots of very hot steam and shards of metal flying around.
In the case of water, a BLEVE could occur if a pressurized chamber of water is heated far beyond the standard 100 °C (212 °F). That container, because the boiling water pressurizes it, is capable of holding liquid water at very high temperatures.
If the pressurized vessel, containing liquid at high temperature (which may be room temperature, depending on the substance) ruptures, the pressure which prevents the liquid from boiling is lost. If the rupture is catastrophic, where the vessel is immediately incapable of holding any pressure at all, then there suddenly exists a large mass of liquid which is at very high temperature and very low pressure. This causes the entire volume of liquid to instantaneously boil, which in turn causes an extremely rapid expansion. That expansion is so rapid that it can be classified as an explosion, fully capable of inflicting severe damage on its surroundings.
Imagine, for example, a tank of pressurized liquid water held at 204.4 °C (400 °F). This vessel would normally be pressurized to 1.7 MPa (250 psi) above atmospheric ("gauge") pressure. Were the tank containing the water to split open, there would momentarily exist a volume of liquid water which is
at atmospheric pressure, and 204.4 °C (400 °F).At atmospheric pressure the boiling point of water is 100 °C (212 °F) - liquid water at atmospheric pressure cannot exist at temperatures higher than 100 °C (212 °F). It is obvious, then, that 204.4 °C (400 °F) liquid water at atmospheric pressure must immediately flash to gas causing an explosion.
Please put a pressure relief on or at the very least a pressure gauge. Please. A jet of steam that scalds you when it's getting too hot is much better than an explosion of steam.
I don't know what the laws over there are but in the UK by law all pressure vessels over a certain values (yours is, or could be) have to be inspected regularly to help ensure they're safe.
-
Ok Il make it safer Cupboard
like I said I didn't make it.
if I would have I would have included a safety pressure release.
-------------------)--)))----------))))----------))-))))---)))--//--////---\llllkk
todays' thoughts
I'm thinking I might drop the little boy from this review.
I don't know where else to look and buying / using a new one would not be fair .
if I just do it only on fat man I will try and use it for all my work and off work projects
I will carry whatever I feel like when I'm off work and grab the st300 as needed.
sorry I lost the little boy and in doing so wreaked my chance and a 2 for 1 topic /review. I didn't plan on what I should do if I lose a tool.
-
Well since I hear no objections.
I'm going to grab my spyderwrench.
if little boy shows up we will continue where we left off
Little boy
Born 7/13
M.I.A. 1/14we will never forget
-
it ain't dead yet. if it turns out it will have a good fade in story to tell
-
Shame about Little Boy but I think you've made a good decision

-
Well its Monday and I'm back at work.
on break right now from playing electrician.
first I had to find the problem. A faulty outlet. Why is the outlet fouling. Bad wiring so I removed the damage section replaced it and put it all back together.
the wire striper on the can opener has become my preferred tool to strip wires
its way easier than using the pliers cutters. I think. I don't accidentally cut wires im trying to strip when I use itstripping

putting it all back together nicely.

fat man is a real hard worker. He takes a beating and asks for more .
I'd replace it with a st300 just like it if I was to lose or break it.
I don't see myself replacing it for a long long time.
When the st400 comes out I will lol -
We'll JA I'm conviced I ordered my own fat man last night.
Sent from my Sega Dreamcast.
-
@hrvstmn31 said:
We'll JA I'm conviced I ordered my own fat man last night.Sent from my Sega Dreamcast.
I don't do reviews to sell tools for leatherman but I'm glad you are going to get one.
you will be very happy with it.
I am with mine.
-
I am happy with mine too.
-
-
Ha, you're a great Leatherman salesman Joel, even if you're not trying to be
;) -
We'll JA I'm conviced I ordered my own fat man last night.
Sent from my Sega Dreamcast.
I don't do reviews to sell tools for leatherman but I'm glad you are going to get one.
you will be very happy with it.
I am with mine.
Maybe you should or at least contact them and tell them you review them! They might get you another little boy! :D
-
Maybe you should or at least contact them and tell them you review them! They might get you another little boy! :D
[/quote]dear leatherman
my dumb ass lost my rebar and I need a new one to show off.
thanks
sincerely
one of your customers that doesn't surf
Joellol
really though
you ask them for me. Tell them to send it in a unmarked package so I won't be biased because I Got a free tool from them.

I expect my mailbox will be leatherman free for the near future.
They are busy researching what tool the professional snow shoer needs to tighten his binding's or some Smurf like what tool does the backyard horseshoe player need .
lol who knows lol
I think that they quit giving a crap what the working man is up to long ago. There would be a civilian mut by now if they did. Lol
i still love my Leatherman tools.
why because they make a good tool.
-

Hey I like playing horseshoes. I wonder what kind of tool they could come up with for that

-
Give the Backyard horseshoe player a bottle opener and they are all set :D, in reality though it would be really great if they got back to making tools that are worth the effort. I know they aren't universally loved on here, but at least the sidekick/wingman was aimed at a viable market, there is plenty more they can do besides this recent nonsense.
-
So here is the real question, is ST300 your most favored MT out of everything you have?
-
@Higgins617 said:
Give the Backyard horseshoe player a bottle opener and they are all set :D, in reality though it would be really great if they got back to making tools that are worth the effort. I know they aren't universally loved on here, but at least the sidekick/wingman was aimed at a viable market, there is plenty more they can do besides this recent nonsense.Ha, a bottle opener is a great idea...definitely a necessity for backyard horseshoes
I love the Wingman/Sidekick myself, but I'm not a fan of all these recent offerings. I understand they're not aimed at the typical user though.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login