Investment cast
-
I've been reading about investment casting and I have known for a while that Leatherman, SOG, Gerber pliers are made using this method. From what I read and I may be wrong is that investment casting doesn't leave seams:
From Wikipedia - A very smooth surface is obtained with no parting line.
If that's the case why does my supertool 300 have huge seam lines? Maybe I'm not completely understanding the process. J-Sews please comment on this :-)
Sent from my DROID RAZR using Tapatalk
-
I will have to look at my Surge when I get home. Never notice any lines in it.
live from Nate's mobile
-
Mine has a line, but only on the needle nose part of the pliers.
I think it is done by design. It does make it look a little beefier.live from Nate's mobile
-
Great question Dave. In this case I disagree with the "no parting line" statement on Wikipedia. Investment casting (also called lost wax casting) is quite a lengthy process, which can vary somewhat depending upon the volume of parts being produced. I am certain that at the rate Leatherman cranks out multitools, all of their plier heads start out as wax dummies created in an injection mold having multiple cavities.
The mold used to create the wax dummies is made of steel and consists of two halves; a top and a bottom. So the wax dummies have a seem where the two halves come together, and that seem is then apparent on the plier heads. On some pliers the seem is ground off (old PSTs, SuperTools, Waves, etc.) On newer tools like the Rebar and the Super tool 300 they don't grind the edges, so you can still see the seem. It is usually quite faint and hard to see. But after a while the steel mold halves start to wear and not line up with each other as well, and the seem becomes larger and more noticeable. :-\
That's my take on it anyhow.

-
I thought I was correct but wanted clarification. Made from 400 series stainless if I remember correctly. I'm loving the new plier head, great design and fantastic wire cutters.
-
Hopefully not off topic, but are the wire stripper heads on the E4/ES4 and scissors on Micra, etc., investment cast, or are they stamped, or something else entirely? And if they are stamped, would that make them more or less likely to chip or snap?
-
Two answers here. First, as pointed out above, is that investment casting is only as clean as the wax that goes into the investment. If it has flashes, you'll have flashes on the final cast product.
Second, I don't think they just stick with investment casting alone. From the condition of the metal and the uses intended, I suspect the parts you're looking at are investment cast to get a fairly precise dimensional tolerance, and then are strike-forged in one fashion or another to improve the strength of the part. Investment casting is just a matter of potential precision; it doesn't make a piece any stronger than a simple piece of pig iron might be, unless you use a better alloy and post-treat it. The post-treating here, if done, could easily leave the same marks on it.
-
Hmm, wish I could get a detailed process from Leatherman on how they make their plier heads. I'm very interested in the process.
Sent from my DROID RAZR using Tapatalk
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login