SAK as a keyring
-
That all depends...
I wouldn't put it on my key ring, but then I have a key on my keyring for my wife's car that has the remote on the back end of it:

It's pretty big... just measured, and it's 90mm long, so it's about the same length as a 91mm SAK. It's not as heavy of course, but it is wider than the average SAK.
Seems like it would be a lot for a pocket... but on the other hand I carry my huge 91 cybertool mod in my pocket daily... so who am I to say that it's too big. Now... 111mm on a keychain... that's clearly too big! :)
-
I dont think its the length more so than the layers that would be an issue.
-
After looking at tons of people's keychains, I'd say no.
People with literally a fist worth or steel in their pockets. Half of which is just split rings...I don't get it. Especially women's keys.With that said I couldn't see anything larger than a 2 layer on the keys.
Compact would be king. -
@haulinthedollaghan said:
Do you think a 91 mm SAK is to big for a keyring?I don't think so, provided that (a) we're talking about a model that is only two or three layers and (b) you don't have too much other crap on your key ring already. I could see something like a Swisschamp being a bit much on a key ring, though, and truly excessive weight hanging from a vehicle key while it is in the ignition switch can eventually damage the ignition switch.
I carried a Spartan on my keys for a while. When I decided to discontinue carrying it that way, it wasn't because of any issues carrying the key ring or using the keys with the SAK attached; rather, it was because I found it awkward to use the SAK with the keys attached, and instead of detaching the SAK from the key ring before each use and reattaching it afterward, I was better off to simply carry the key ring and SAK separately. YMMV though.
-
Why not? :D
If you plan to place the 91mm in the bottom or alongside with a fist full of keys, either it is attached to the keyring or not, it will pretty much among all the keys.
The only slight difference is if you attach it to the keyring with a short lanyard, so it will be long enough to pull out of pocket and can be detached via a quick release clip. The benefit of this arrangement is to also allow the 91mm to freely align itself inside the pocket, so it will sit flatter inside the pocket.
-
Personally, I don't carry any SAK on my key ring. The keys just get in the way.

-
I heard that heavy key chains can prematurely wear out or break your cars ignition barrel. Just what I heard!
-
As others said before me, I think a slim 91 or 93 SAK would fit on a keyring where there is not much junk already. Big decision factors would be if you carry it in a pants pocket or in a purse/wider pocket/backpack... and how wide the SAK is. I think the width is more importent than the length.
-
@nmpops said:
Personally, I don't carry any SAK on my key ring. The keys just get in the way.
My thoughts exactly. Plus my leg is fairly close to the ignition barrel in my little Peugeot so that even other keys are annoying. I tried my new 58 mm Vic Classic on my keyring and even that was in the way.
-
@Fattsgalore said:
With that said I couldn't see anything larger than a 2 layer on the keys.
Compact would be king.I used to have my c1989 Golfer (a compact by any other name) on my keys for years, nearly wore through the "keyring attachment" hole. But it never bothered me or the lock barrel of the car. But cars were tougher back then. (and so was I)
-
For me, function is extremely important. If I tried to tighten or remove a screw with a pack of keys on it, it would make me crazy. I attach SAK's to keys with a snap of some type. Lately, I've been using small NiteIze S biners.
-
How about installing a clip (nite ize micro for instance) on you keyring so you can detach the sak when you need it? :)
Sent from my Nexus 7 using Tapatalk
-
@Mike, Lord of the Spammers! said:
How about installing a clip (nite ize micro for instance) on you keyring so you can detach the sak when you need it? :)Sent from my Nexus 7 using Tapatalk
I can't see doing it any other way. I just use one of those one piece little spring clips that are from neck lanyards like come with an ID neck cord or coaches whistle neck lanyard. That way I can take my classic off my keys in just a second. Or you can use the keychain sheath Vic makes.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login


