Question about Pocket Wrench 2 knockoff
-
Give me a minute to take some pics.
-
OK, short answer, stick to the original. ;)
I got a few to try some mods on but cave it a test run before starting those to see how they worked.

After a few weeks one started developing rust.
Apparently not so stainless stainless steel. ::)
The second one didn't but came with botched up teeth. Seems they weren't cut properly or they cut them off at some stage. So forget about bigger screws. The "rusty" has very good teeth though. Original on the bottom here.


Thickness wise I was a bit surprised as I expected them to be much thinner, but they are just hair thinner than the original PW2, maybe 0,5mm at most. Original on top.

Finish on them is so so. You can tell they jumped a step or two. Original on far right.


All of them take the 1/4" bit well.

-
They were all made in USA? :o
-
Great, now I'm considering even more to get a knockoff, just to see if I could get along with a OPMT... And I don't even need any of the functions it has.

-
-
Thanks for the work, enki_ck.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login

