Help! Shooting related question
-
@jerseydevil said:
Hmmm..... I'm wondering if it's the bedding of the rifle Kirky. Have you checked to see if the stock is making any contact with the barrel at all, or if the action might have shifted a bit in the stock? I'm assuming that there's no lightening cuts to the action, which is what's usually blamed for the most famous example of a wandering zero. For the record, I've never been able to shoot a No.5 MkI accurately enough to prove or disprove the theory. Bloody thing kicks like a mule! :ahhh Its' bigger brothers No.1 MkIII and No.4 are much more docile.
Anyhow, two scopes doing the same thing makes it sound like the bedding is off to me.That's what I was getting at with my question as well.
-
Yeah with two scopes doing the same thing, I'm not thinking it's the scopes themselves.
-
@jerseydevil said:
Yeah with two scopes doing the same thing, I'm not thinking it's the scopes themselves.Exactly my thoughts.
-
I'm perhaps thinking of a droopy barrel. Are you having to make serious upwards adjustment to the scopes?
This says it far better than I ever could:
-
Could be a number of things, but first thing I would start with is making sure that your bases and rings are tight. Can't tell you the number of scopes I've "fixed" for customers just by tightening down the mounts. Also make sure and tighten down the action in the stock. Next barrel droop, stock could be pushing into the barrel, stock could be improperly sealed and allowing it to expand and shrink with moisture content, or bedding of the action could be the issue. If you are still experiencing the problem after these checks, and they aren't the issue, then I would invest in a good torque wrench and check your action screw periodically. You may have the action screw compressing the stock and then it is changing shape in the heat, making the action itself wobble in the stock with less pressure on it. If that is the case a simple trunnion or pillar bed will fix the issue.
Your Nikko shouldn't be losing zero to either of the reasons you put forward. Short of you dropping it or putting it through extreme heat change that would be an indicator of a pretty poor optic.
-
I was about to say Leapers and Nikko Stirling are very low end brands and that air rifles are notorious for busting scopes and that it might be worth getting a dedicated air rifle scope or something a bit nicer... but if two scopes did it straight after each other it sounds a little suspect.
I hate scope problems... I'm having issues with my 6-20 Weaver Grand Slam on my 7mm at the moment :(
Is your rifle one where you pull the barrel down to cock it? The barrel isn't loose or wiggly is it?
-
@RimfireNZ said:
I was about to say Leapers and Nikko Stirling are very low end brands and that air rifles are notorious for busting scopes and that it might be worth getting a dedicated air rifle scope or something a bit nicer... but if two scopes did it straight after each other it sounds a little suspect.I hate scope problems... I'm having issues with my 6-20 Weaver Grand Slam on my 7mm at the moment :(
Is your rifle one where you pull the barrel down to cock it? The barrel isn't loose or wiggly is it?
No, Kirky's rifle is an underlever (a Weihrauch 97 to be exact). :)
-
Gents,thanks for all the answers and suggestions.
I'll go through this again in the morning when I'm sober

-
Stupidly, I seem to have given myself a bout of tennis elbow from overdoing it with my WH57.

-
-
Stupidly, I seem to have given myself a bout of tennis elbow from overdoing it with my WH57.

Can't say I've ever experienced that issue from a rifle. M1 Thumb isn't much fun though, that I know.....The 'issue' with the HW57 is that it's a spring powered air rifle and so need re-cocking after every shot. :-\ It's not particularly heavy as these things go, but it's also far from effortless. I spent one happy afternoon doing this and sent around 200+ shots down range. :-[
This is only a guess of course, it might have been something else entirely, but the rifle seems like the best candidate to me.

-
I see. After 200 rounds downrange in an afternoon, I'd have a rather sore shoulder, and my left hand would probably be cramping a bit from working a bolt that often. It's been a while since I've gone to the range and touched off that many rounds in one sitting......
I did get out two Sundays ago with a buddy, and brought my 93 Spanish Mauser along for some fun. I only had 40 loaded rounds of 7X57mm on hand though. :( -
Stupidly, I seem to have given myself a bout of tennis elbow from overdoing it with my WH57.

Can't say I've ever experienced that issue from a rifle. M1 Thumb isn't much fun though, that I know.....Had to look that one up: http://www.garandgear.com/m1-thumb
Ouch! :o
You can actually do something similar, if not nastier, with a spring powered air rifle. There is a pretty grizzly video on youtube you can look up, but I'm not going to post it here. Safe loading technique should prevent this from ever happening.
-
Stupidly, I seem to have given myself a bout of tennis elbow from overdoing it with my WH57.

Can't say I've ever experienced that issue from a rifle. M1 Thumb isn't much fun though, that I know.....Had to look that one up: http://www.garandgear.com/m1-thumb
Ouch! :o
You can actually do something similar, if not nastier, with a spring powered air rifle. There is a pretty grizzly video on youtube you can look up, but I'm not going to post it here. Safe loading technique should prevent this from ever happening.
I'm guessing bear trap failure?
-
Just a thought, as its a HW97 which has a fixed barrel there should be no barrel droop. Are you useing a stop pin in the rear mount (the 97 has 3 holes for a pin). When you put the action into the stock always tighten the rear (trigger guard) screw before the front stock screws. After a shooting session always check the stock screw tightness, they can work loose on a springer. Hope this helps. Stan.
-
Guys,again thanks for the responses!
@Capt Spalding and JD: The bedding of the gun is fine,it's not been altered since I scored a new PB about six weeks ago. The first stock the 97 was in had issues of this nature,so it's the first variable I check! Interesting stuff about the No5 service rifle though!
@dmanuel: D'oh!
You might be onto the winner. Had a look this morning,and think I could see evidence of movement of the scope within the mount,tried the lock screws,and lo and behold! I've painted a line longitudenly along the scope and the mount,hopefully this will indicate any further movement,should it happening.@RimefireNZ: Yeah,you have a point about the scopes I use being low end products. There are two reasons for this...
My first rifle was a BSA SuperSport,and they're legendary for breaking scopes,so I never seen the point in buying a good one! Secondary problem for the foreseeable future is budget. Having said that,I get results( when I'm on form) as good as folks using high end optics,so I'm disinclined to spending the dosh :D
@Gareth: Barrel droop? I have pills for that,thank you very much!
Joking aside,I'm doing another comp on Sunday coming,so we'll see what happens next.
-
@bigstancwsw said:
Just a thought, as its a HW97 which has a fixed barrel there should be no barrel droop. Are you useing a stop pin in the rear mount (the 97 has 3 holes for a pin). When you put the action into the stock always tighten the rear (trigger guard) screw before the front stock screws. After a shooting session always check the stock screw tightness, they can work loose on a springer. Hope this helps. Stan.Cheers Stan,yes I am using the stop pin. Given how the SuperSport used to throw the mounts along its rails,it's something I love dearly!
I have checked screw tightness,but that's interesting on the reassembly order,I'll remember that

-
Stupidly, I seem to have given myself a bout of tennis elbow from overdoing it with my WH57.

Can't say I've ever experienced that issue from a rifle. M1 Thumb isn't much fun though, that I know.....Had to look that one up: http://www.garandgear.com/m1-thumb
Ouch! :o
You can actually do something similar, if not nastier, with a spring powered air rifle. There is a pretty grizzly video on youtube you can look up, but I'm not going to post it here. Safe loading technique should prevent this from ever happening.
I'm guessing bear trap failure?
IIRC the guy had the butt braced on his hip, one hand on the barrel, one hand on the forward stock. As he was just about to bring the barrel back to it's locked position the butt slipped off his hip casing the whole rifle to shoot backwards and his hand on the forward stock to shoot up towards the breach, thus removing about 1/2 an inch from the top of his thumb as the breach snapped shut on it. :-\
-
[quote author=Gareth link=topic=53236.msg912503#msg912503 date=1404855895]
Stupidly, I seem to have given myself a bout of tennis elbow from overdoing it with my WH57.
Can't say I've ever experienced that issue from a rifle. M1 Thumb isn't much fun though, that I know.....Had to look that one up: http://www.garandgear.com/m1-thumb
Ouch! :o
You can actually do something similar, if not nastier, with a spring powered air rifle. There is a pretty grizzly video on youtube you can look up, but I'm not going to post it here. Safe loading technique should prevent this from ever happening.
I'm guessing bear trap failure?
IIRC the guy had the butt braced on his hip, one hand on the barrel, one hand on the forward stock. As he was just about to bring the barrel back to it's locked position the butt slipped off his hip casing the whole rifle to shoot backwards and his hand on the forward stock to shoot up towards the breach, thus removing about 1/2 an inch from the top of his thumb as the breach snapped shut on it. :-
[/quote]Ouch!
I had a trigger seer fail during the cocking motion. Whole gun leapt from my hands. Fortunately it didn't hit any one. Bloody embarising thought!
-
Quick update
Went down to do the home shoot at Horsham this morning,done a new PB for the course on 46x60. Not a great score,but it was a PB,and every kill I missed,I missed...not the gun!
Thanks again everyone for your help

Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login