crackout's Adventures in Alox.
-
I used a modern 91mm scissor spring in my Urban Cadet (84mm Cadet, with 84mm vintage scissors added). There are two issues to overcome:
1.....the hole the scissors spring locates into is too small for a modern spring. I very carefully ground (Dremel, sanding disk) just a smidge off the curl of the spring, then squeezed it down till it fit the hole tightly.
2....when the scissors close in the knife, the spring is a bit too "open" to permit proper closure. I used a small pin punch in the offending spring bend, and closed the radius till the scissors closed fully. The pin punch was used as a support/stop, in case I closed the spring too far and flattened it.
All told, it only took maybe 10 minutes to modify to my satisfaction. And it's a lot easier than trying to locate a vintage spring. -
I like it, very nice job.

-
BTW, Happy birthday.

-

Finally I could give my Pioneer a red shield! :D
-
It got nice new clothes. :D
-
This will be the next mod. I just have to find some time to redrill the holes (OH 111mm and Slide-Lock 111mm have different hole sizes).

And I finally got a bigger box to store all the fodder in. :D

-
-
I found a perfect condition vintage Golfer and decided to harvest the thick tang blade and the nice scissors for my beloved Cadet to replace the modern blade and the converted 91mm scissors.



:tool:
-
Gorgeous looking mod. Lately I've fallen out of love with the standard bottle opener, and now I'm more a fan of the combo one.
-


I give you: the OHutrider :D
-

Did you drill out all the Outrider parts to OHT size?
-
Yep.
-
But now it's no longer DE legal, right? :\
I'll give ot a good, loving home.

-
I was thinking about a fast way to add a scissors rest to solo springs and came up with this:

I used a thick dremel cutting wheel to create the slot and then hammered two thin 1.5 brass pins in (one from each side). Sand to perfect length and you're done. :D
-
nice job crackout!
JR -
Looks good, I might try that with my next transplant. Maybe use a piece of sheet rather than two pins?
-
I always wanted to try and add a backtool to a 84mm Alox knife, especially an awl. I used the spring and the tools of a 84mm Climber. The awl sits in the opener layer.

Goodies: Danish Cadet scales, peened and resharpened 84mm scissors, heat coloured screws.
-
I figured they would work since the cadet are the same size. Looks good!

JR -
Shots of the backside.


Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login