How to remove the bail?
-
Is it like the bail on a Wenger SI? They flick out with a flat screwdriver.
-
Do you mean the bail where the rivet goes all the way through?
answer is CAREFULLY!
Try filing a flat on the end with a fine tooth file then centre punch (lightly) to make sure the drill doesn't wander. Drill well undersize and using a dental burr cut around the inside of the hole so the whole end of the rivet comes off. No danger of marking up the bail.
Alternative method if you plan to replace scales would be cut the rivet down between the scale and outer liner with a razor saw.
-
DON'T DO IT!
Send it to Ibach for the TLC it deserves.
-
Will Victorinox work on a 50-year old knife? The bail was discontinued in 1968.
Drill out the ends of the pins as PTRSAK says. Only the very ends, then pull off the bail, then carefully peen the pin-ends flat. You probably won't have enough brass there to file the ends before peening. -
Don't abuse the privilege, but in a bit word yes.
Ibach is where the special cases should.go, and make sure to send the requested shipping. One good turn deserves another.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login

