File question
-
@E-dog said:
The teeth run the entire length on mineIs yours the one with the flat screwdriver tip end and on the Pocket power plier ?
Dunc
-
The file with the round tip is the old design and I think that they where made before SOG started making tools with locking implements and when they started making the Powerlock they changed the design of the file.
-
Dunc, I've got some PPP's with the flat tipped file, and some with the round tipped file. So they both fit fine.
On the ones with flat-tipped files, the teeth do run further along the edge than yours do. :-\
Are you thinking about swapping files on yours?
-
Yeah, my files seem to be interchangeable too.
I love playing SOG lego :D
-
I think I had better get mine changed over then

Dunc
-
Dunc I went and checked all my SOG MTs. Two P3 one stainless and one BO have files like you pictured above . The rest have teeth the full lenght of the file.
-
-
Dunc , looks like you have a bad one there mate. The edge of the file is basically the metal saw (and a decent one) but the teeth have to run the entire length of the blade. I'd look into that for an exchange. Not sure but the first picture you have does show there are slight lines on the smooth part of the edge, maybe the file was mis -stamped or the teeth not properly cut.
-
@Nutznboltz said:
Dunc , looks like you have a bad one there mate. The edge of the file is basically the metal saw (and a decent one) but the teeth have to run the entire length of the blade. I'd look into that for an exchange. Not sure but the first picture you have does show there are slight lines on the smooth part of the edge, maybe the file was mis -stamped or the teeth not properly cut.Well I've done a successful file transfer and put the rounded tipped file in its place . I also put a flat end Screwdriver bit in each handle aswell .Worked out fine . The only trouble I can see so far is the lanyard ring wont turn without undoing the screw :( I'll wait until the morning to give the loctite a chance to go off before I take a closer look .
Dunc
-
Personally I like the rounded file much better, feels coarser and therefore would cut/shave metal much better. Though the flat tipped one doubles as a screwdriver mines don't feel very rough on either side. The saw portion does cut well on both versions.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
