Bit mod for Raker Ring Tool
-
I wanted a way to use a Phillips bit in the Raker Ring Tool's 1/4" hex hole. The problem was that it kept falling through. I found that a 8mm jump ring fits perfectly on the bit. All I did was glue it in place with White Gorilla Glue. Gorilla Glue is good because it expands and fills the gap between the ring and the bit. You can do this easy mod with any 1/4" bit. If you are looking for 8mm jump rings, check out http://www.artbeads.com/split-s08.html . Artbeads has free shipping with no minimum purchase.
.jpg)
.jpg)
.jpg)
-
Very nice mod. Seems a slightly better solution that the o ring idea, but now you have to make the bits specific to the tool, instead of just buying new ones, but very nicely done.
-
@Zack said:
Very nice mod. Seems a slightly better solution that the o ring idea, but now you have to make the bits specific to the tool, instead of just buying new ones, but very nicely done.Yeah, I didn't have to modify the tool in though, which is good because I rather screw-up a bit than this beautiful piece of Damascus. I think I'm going to make a couple and carry them around in a pill fob with the tool.
-
ari6126,
That looks good to me. You can put a bit more pressure on it like that. Being a bit more technical, you could solder the ring on and then it would be stronger. Once you get started thinking of things, they just keep poping up. :)
Thanks -
Great idea Ari

-
Great concept!

-
Nice job that mate

-
Good one..

-
Good thinking there, I like it

-
Nice idea, I used a long shank adapter from a cordless drill but your idea is much more compact.

-
Impressive

-
Thanks for all the encouragement. The one problem with my mod was that the bit would just fall out the other way. So, another solution. I bent another 8mm jump ring to make it have a smaller diameter. I sandwich the ring tool between the glued ring and this new ring. Holds the bit in perfect. The retainer ring stores on the bit.
.jpg)
.jpg)
.jpg)
-
I made one more thing. I cut off one of the bit holes in my plastic bit holder. I drilled a hole in it, and attached a split ring. Holds the bit, and is much smaller than a pill fob.
.jpg)
.jpg)
.jpg)
.jpg)
-
Better yet!

-
Bloody good idea, can i use pls?
-
Ha, that's neat!
-
That's using the ol' noggin.

-
Thx, i made one tool-knife, end this idea perfect too me!
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
