Surge Blade Exchanger Problem
-
Amici,
I have suddenly encountered an issue with my Surge.It seems that the blade exchanger now releases the saw any time I attempt to deploy it from the closed to the open position.
This is a new tool, and has not been abused in any way, so I'm sorta perplexedd by this and thought I would bounce it off of the forum to get some sort of an "A" for this particular "Q"..
Once again whenever I try to deploy the saw, it comes right out of the exchanger, any ideas?
Cheers,
Serge

-
yep, the latch is hitting on the handle. Its happened on mine before. If you put alot of side pressure on the file when using it that will bend it out. If its not too bad you should be able to bend it back in.
-
Same with mine.I just release the saw and squeeze exchanger,using pliers.The problem was solved.

-
I'll give it a shot, but it looks like that the ittle ball is suddenly "worn" down, and there's not even much of a nub to secure it..
If I was able to, I would mod out my Surge and replace the exchanger with a saw from a Wave, then the problem would be solved once and for all..
Cheers,
Serge
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login