Leatherman Bit Drivers
-
I like them. The bits are nice because they're interchangable and double-sided. I also really like that they are made out of tool steel instead of stainless so they have hardness more like a good screwdriver. And, in the event you do strip a driver, you can just replace it.
The downsides of course are that they are short, and that you have to buy them from LM. If you find a good place though, they arent too expensive. And I've found that because I run into situations where there are recessed screws AND situations where I need a short 90 degree driver, it's about 50/50 IMO as to wether short or long is more useful.
All that said, I also like the "regular" drivers and know that they have benefits as well...
-
I prefer standard 1/4" hex bits myself, as they are easier to come by when lost or broken.
Def
-
I thought I was going to hate the Leatherman ones on account of how short they are. But so far they have not been a huge problem. The couple of recessed screw jobs I've ran into had holes so small and so deep that no other dedicated multitool screwdriver would have worked anyway.
-
@J-sews said:
I thought I was going to hate the Leatherman ones on account of how short they are. But so far they have not been a huge problem. The couple of recessed screw jobs I've ran into had holes so small and so deep that no other dedicated multitool screwdriver would have worked anyway.I think most people had that opinion initially,but evidently Leatherman's R&D did their homework.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login