Leatherman Mod Question
-
I can't answer conclusively but if it's possible at all it would be very difficult:
The file would have to go where the wave's/charge's file is, which is held locked with a liner leaf spring meaning the bottom of the PSTII's file would need to have the corresponding flat added.
The opening limit notch (the piece of the file that hits the handle to stop it opening more) is in different place from the wave/charge version.
The pivot hole may well be a different size.
The original nail indent wont help pull out the file so a new way of opening it would need to be found.
All changes would have to be done to hardened metal as annealing it would probably ruin the diamond bonding and getting back to the right hardness afterwards wouldn't be fun.
If the file is the same size as the PST file which i suspect it is, the file is shorter and also not deep enough to reach the opening limit rest on the wave/charge.
From my own comparisons the PSTII file looks completely incompatible with the wave/charge.In conclusion i personally would not recommend doing this, It would probably end up a waste of a good file.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login