Corrosion and Rust
-
Hello
I got a few old Swiss army knives. Some of them seem to have a fungi or corrosion(I believe its corrosion). The corrosion seems to be in the inner part of the swiss knife(the inner metal scales that the plastic scales are stuck to).
The stainless steel blade nick seem to have a bit of rust on them. One of the knife logo on the scale has rust over it.
Any idea how I clean the rust/corrosion with out the damaging the plastic/metal and polishes.
How would I rub it in the knife, its impossible to get a cloth in the inner part of the knife.
If you need pictures just ask.
Thanks. -
Try polishing the rusted spot with wet aluminum foil.
From wikipedia:
Aluminium foil is used to remove rust from steel and polishes steel surfaces by hand by rubbing it with aluminium foil dipped in water. The aluminium foil is softer than steel, and does not scratch the surface. Heat is generated by rubbing friction, the aluminium oxidizes to produce aluminium oxide. Aluminium has a higher reduction potential than iron, and therefore leaches oxygen atoms away from any rust on the steel surface. Aluminium oxide is harder than steel, and the microscopic grains of aluminium oxide produced create a fine metal polishing compound that smoothes the steel surface to a bright shine.
-
That's good !
-
@lister said:
Try polishing the rusted spot with wet aluminum foil.From wikipedia:
Aluminium foil is used to remove rust from steel and polishes steel surfaces by hand by rubbing it with aluminium foil dipped in water. The aluminium foil is softer than steel, and does not scratch the surface. Heat is generated by rubbing friction, the aluminium oxidizes to produce aluminium oxide. Aluminium has a higher reduction potential than iron, and therefore leaches oxygen atoms away from any rust on the steel surface. Aluminium oxide is harder than steel, and the microscopic grains of aluminium oxide produced create a fine metal polishing compound that smoothes the steel surface to a bright shine.
Nice info

-
I just used some steel wool #0000 Super Fine to clean up a SwissTool with good results.
-
The white coloured patches you see on the aluminium parts are corrosion, not fungi.
Aluminium can be easily cleaned to remove that (if needed). They usually occur when the protective layer, formed by (controlled) oxidation of the aluminium is removed by scratching and oxidants (sweat, washing powder) can act, until enough oxidation is formed to provide protection. -
same thing happened to my severely neglected sak. what i did was scrape the 'corrosion' of the aluminum.
-
I tried the foil on some metal outside that was rusted and worked.
So I can fix the nick of the knife.
But the rust on the logo I'm not sure.
Its a different metal."That "gold tint" of the tweezer-end is the high-brass "nickel-silver" alloy Vic used before the aluminum of 1957 (like on the old "gold" shields too)."
I think it could be nickel silver. Not sure if the foil would work for that or hurt it. Could also hurt the plastic scales.
Its a old knife so I'm wary of using foil.
The corrosion is inside the knife where the main blade sits. Hard to get to.
I will put a pic tomorrow so you all know what I mean.
Thanks for the help.
-
Here are some pics.
See how its in the knife.
In the last pic the logo has rusted a bit. Its not stainless steel so I won't use aluminum foil on it.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login