Clip?
-
Im working on some Ti wrap around style now that uses the main pivot to hold it on, but I haven't got it done yet. Its either going to be just a thin rectangle held in by a milled slot, or a full liner size one piece with the clip wrap around style.
I tapped the aluminum scales one time for a screw on clip, but I never liked relying on screws in soft material and loose clips are the worst!
-
I taped my Edc alox explorer and it's be going strong now for about 8 months :). As syph said though, aluminum is a tricky metal to tap properly. I bought a 2/56 drill and tap combo set. Also you need to use the correct thread lubricant for aluminum. I also used blue loctite to keep it there.
-
Got a low rider Ti clip on a 93mm Alox - Neil did it by tapping the scale :)
Seems to be holding up very well.
-
I think I might be more likely to trust the stock clips with three screws. The one I did, I just wasnt happy with, I was so afraid to strip out the threads.
As an afterthought I think I would have just used brass pins and riveted the thing on, with a countersunk hole on the inside, and sand the inside rivet flush. That has to be stronger than tapping. But then you cant get it off either... pros and cons I guess.
-
@Syph007 said:
As an afterthought I think I would have just used brass pins and riveted the thing on, with a countersunk hole on the inside, and sand the inside rivet flush. That has to be stronger than tapping. But then you cant get it off either... pros and cons I guess.Yes that would be a solid fitting. But how would you peen the pivot with a lowride clip? (like in the picture on the left). I guess for someone like me, easiest would be to just tap the scales and screw the clip on.
On the right in the picture you see a Soldier with hollow rivet. Hmm, perhaps I can use a torx pivot (or something) to bold it on, and leave the vintage scales untouched that way?
Got a low rider Ti clip on a 93mm Alox - Neil did it by tapping the scale :)
Seems to be holding up very well.
Yep same as I did. Also if you get a tap kit, get 2 taps. One regular and one bottom tap. You can do this with the knife still together just be very careful.
Thanks.
One of you got a picture to show?Thanks everyone for the great respond.
Happy new year!

-
Sure do ;)

-
That's the one! Very nice Steve

Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login