Slim single AA flashlight?
-
Romisen, Tank007 have a few simple AA ones.
The romisen RC G2 is avery nice thrower, with tactical on switch and very solid. http://budgetlightforum.com/node/14646
Also, for tighter beam look into the SIPIK 68 models too, with zooming lens.
Even Trustfire has a few nice AA ones that run on AA, as well as 14500, like the F25 with a low mode too for longer running (I have some comments in the review section)Also the usual suspects (Fenix, Jetbeam etc)
-
Thrunite Ti is simple with long runtime on low, but with optional higher mode ... it's a twistie and partially tighening will get you low and full tightening leads to full power ... simple, cheap, and two easily selectable modes for power OR runtime
Nitecore T0 is a similar body but single mode - 12 lumens for 21 hours
Gerber Tempo similar state of affairs I thinkFor tight beam consider the LED Lenser P2 ... you'd need to check light levels and runtimes, but be aware I think their runtimes listed are to zero output or something equally unhelpful
-
Steinar, any info you can provide on your intended use and budget for this torch? That'll help me help you with some suggestions.
The previously mentioned candidates are good suggestions. If you're looking for something that'll be a solid and ultra-dependable light, I'd suggest the EagleTac D25A. They go for about $45 US, but I don't know what that translates to in quid, Euros, or the like.
For a budget light, I heartily endorse just about anything Romisen makes. Shiningbeam.com has the best selection of them of any online seller that I've yet seen.
-
I used to buy cheap lights, but since I have learned a bit about flashlights and bought a few better ones, I've been giving the cheap ones away. When one compares flashlights the way we compare multitools or watches (materials, fit and finish, light output, features, run times, etc.), it is clear why higher end lights are priced the way they are. ;)
With the above in mind, an Olight I2 EOS ($22) would be my least expensive suggestion. For a middle of the road light, a Klarus P1A ($40) would be a decent compromise between price, features, performance and quality. And my actual recommendation is a Zebralight SC52 ($65). Once you've had a Zebralight for a couple of days, and compared it to cheaper lights, you will appreciate the effort they've put into designing and building their products.
Regards,
DaveSent from my iPad2
-
I had a Nebo csi works good until I fell in love with my solarforce x2 super bright small stainless steel and one AA battery.
Sent from my Android toothbrush!
-
@enki_ck said:
Peak El Capitan I think would be a very good option.Have you tried one? I bought one and have to say I thought it was close to the worse light Ive ever used. Horrible build quality, bad anodizing, Light beam was horrible. The infinite adjustable thing was a gimmick. The flashlight head doesnt even have grip so you can turn it easily, its just aweful design and execution IMO. I really couldnt find a single positive about it. I did get a bad one to start with (very bad anodizing) and they sent me another, and honestly it wasnt much better. Ebayed them both off and would never want another.
So for a single AA light, zebralight all the way. Ive got 3 of them and love them! I stopped trying others after a neutral tint SC51w. :D
-
I'd say my budget is somewhere around US $100, though I could potentially go a little higher if it was something I really liked and felt I wasn't throwing money down a pit. (I'm a sucker for nice craftmanship.) Its main intended use is winter nights in a small city in Northern Europe. I walk a lot, and at night it's not well lit everywhere. So, it's simply for taking a look at stuff up in a tree I pass by, whether the park I must pass to get home has been filled with melt water and ice (and I therefore should take another route) and whether it's something inside that bush, etc. Simple stuff like that. I want the light focussed because it feels like shouting otherwise.
The El Capitan in stainless seemed very nice, but Syph007's comment obviously makes me wary. I haven't looked at the EagleTac yet, words like "solid" and "ultra-dependable" ring nice, so I'm taking a look. I gave a Zebralight (don't remember the model, one of CR123 based ones) to my wife last Christmas, so I know the brand, at least. I haven't looked at the SC52, so I'm adding that to the race as well. And I haven't looked at any of the ones Warfusion mentioned (yet). :)
Thanks a lot everybody! Lots of lights I haven't heard about and some I had heard about but didn't know whether they are any good.
-
@50ft-trad said:
Thrunite Ti is simple with long runtime on low, but with optional higher mode ... it's a twistie and partially tighening will get you low and full tightening leads to full power ... simple, cheap, and two easily selectable modes for power OR runtimeNitecore T0 is a similar body but single mode - 12 lumens for 21 hours
Gerber Tempo similar state of affairs I thinkFor tight beam consider the LED Lenser P2 ... you'd need to check light levels and runtimes, but be aware I think their runtimes listed are to zero output or something equally unhelpful
Being a complete pudding, it took me a couple of hours and a rather strong rum cocktail (white rum, golden rum, dark rum, cherry brandy liqueur, and cola) to realise I'd recommended several triple A lights instead of double A

All my previous recomendations are still worth looking at, but back on track ... :D
How critical is size, and how critical is runtime? The Gerber Omnivore will run for ages, and will run on AAA, AA or CR123A, it will also run on batteries that other torches have given up on (the best "scavenger" torch I've found for all three battery types) ... the downsize is the beam pattern is very primative, and it's HUGE!!!
-
Size is very important, runtime is nice, but not extremely important. (Though if it's a battery hog, I want a low-light battery vampire fallback mode.)
Right now I really like the look of Zebralight SC51c and the EagleTac D25A.
Edit: Even though none of those are as simply as I wished for. Seems one can either get nice or simple? I like the UI of the EagleTac better though, not a big fan of the Zebralight UI. Too smart for me. :)
-
Since you prefer spotty to flood I'd have to recommend you stay away from the zebra. An old SF E1B is spotty, a bit big and CR123A cell, so an EagleTac or even some of the Fenix lights might be better for you.
Lumipower use to make some lights with deep reflectors, but most of the smaller pocket ones are going to be more flood. Look for a light using an XR-E led as they will tend to throw more even if you give up some lumes.
I'd recommend you visit CPF and check out some beamshots.
-
Are you thinking tail switch or a twist head? One light that comes to mind is the Fenix E11, simple, slim, tail switch etc. I've not got one myself but it does have it's fans and detractors.
If you want much smaller then a twist on style is likely the way to go. Lots of options there but will tend towards a flood beam rather than a spot.
-
Another (slightly odd) suggestion comes to mind; the Icon Modus 1. Very different from the majority of lights out there. Not the brightest but definitely different. :) Again, I don't own one so don't blame me if it's rubbish. ;)
-
@Steinar said:
Size is very important, runtime is nice, but not extremely important. (Though if it's a battery hog, I want a low-light battery vampire fallback mode.)Right now I really like the look of Zebralight SC51c and the EagleTac D25A.
Edit: Even though none of those are as simply as I wished for. Seems one can either get nice or simple? I like the UI of the EagleTac better though, not a big fan of the Zebralight UI. Too smart for me. :)
Zebralight's UI is a LOT easier in practice than it is on paper. I think you'd get used to it pretty quickly.
For your budget, I'd definitely suggest a ZL; I think they're the best EDC/pocket lights on the market today. No one has the combination of output and run times that ZL is producing right now. They're also very high quality torches; the fit and finish on all of the ones I've got and have had has been excellent.
I'll also second the suggestion for an SC52. I've got one at the top of my list for when they come out with a neutral tint or HCRI version.
-
The way people talk about ZL reminds me a lot of how we always end up telling newbies in the tool subforums to get a Victorinox Spirit. So, as I do have a Vic Spirit, I'm ordering an SC52 as I'm writing this. :)
Thanks for the help, everybody!

-
I'm still trying to get "in-tune" with my ZL. Initially i was far from convinced, but I've decided to give it some time and see if it wins me over :)
-
@50ft-trad said:
I'm still trying to get "in-tune" with my ZL. Initially i was far from convinced, but I've decided to give it some time and see if it wins me over :)I think they do take a little more getting used to than other lights with more 'traditional' UI's, because unlike most lights, you don't just 'click-through' to get to the mode you want.
Probably the most challenging thing about them is learning how long to hold the button to get it to come on in low vs. high. Other than that, best one button UI of any light I've ever had.
-
Foursevens Mini MA
Fenix LD15
Olight I2
Thrunite T10All small, simple durable lights. The I2 and T10 are half, or less, the cost of the ZL, Peak, and EagleTac.
-
@ICanFixThat said:
but most of the smaller pocket ones are going to be more flood.Au contraire, mon frere.
Right now I'm >thisclose< to pulling the trigger on a new Thrunite Archer 1A, it's basically their excellent Neutron 1A light with a forward clicky switch and the latest Cree XP-G2 emitter, which provides abotu 25% more throw than the XP-G (which already throws better than the newer large-die XM-L, which throws fah smurfe without a ginormous reflector). So if you want slim, well-made, simple and throwy, take a gander at the Archer 1A.
-
Throw vs flood in a torches beam is a function of three things: 1) emitter die size; larger die emitters will be floodier than smaller die sizes; the XML is floodier than the XPG which is floodier than an XPE, etc. 2) Reflector diameter; in general, a larger reflector diameter will give more throw as it catches more light given off by the reflector to redirect forward. 3) Reflector depth; not a lot of people realize this, but one of the throwiest lights I have is my old Jet-3 Pro ST which has a reflector that's about 1" deep, though it's only about 3/4" wide. I actually think a deep reflector is better for producing throw than a wide one, but I'm just speculating about that.
-
As said by the previous knowledgeable posters the LED size and the depth and width of the reflector will affect throw.
If you want something small and slim then the reflector will have to be small, thus you will get more flood.
A zooming torch gives you both but these type of torches (i.e. Sipik 68) are not that small.
The Romisen Rc-G2 throws nicely, but again its head is much bigger than the rest of its body, though it is still small.
Both of the above are cheap to buy.You have a high budget so look around and take your time.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login