Advice Please! 1st Mod
-
Best advice I can offer is to read Gareth's stickie in the mod squad.Biggest challenge your looking at is making new pins all round.Maybe practice your peening before starting your build?
-
Hi John, will do, i've got the pin material this morning from local model shop, got enough to make a few mistakes :D
just pm'd you by the way :)
-
Here's a few things I've learned on the way:
- Make doubly sure that you get a good punch mark in the center of the pin before you drill. That way the drill will have something to bite into and not wander around. That also gives you the best chance to save bushings.
- It doesn't take a lot of drilling to pop the head off of the pin. The brass is a soft metal and drills fairly quickly.
- Punching out the pins SMURFS. Get a good punch (1/16" can be used universally). This stage of disassembly is probably the most laborious. If you can, drive the pins out evenly so you can peel off each layer and keep them in order.
- The CT layer has special springs and liners. Don't lose them.
- It's not the end of the world if you lose a bushing or two, it'll just delay you a bit. Try not to lose them. If you drive out the pin with a 1/16" punch, the first bushing should be caught by the punch. The second one can stay on the other end of the pin until you're ready.
- Assembly is pretty fun. Setting the springs, once you understand how to do it, is pretty easy.
- It doesn't take nearly as much peening as you might think. Start with a flat pin surface and work it around until there's no more side play left in the tool. Once you're there, you're done. A 4 oz ball pein will do the job nicely, the highest I might personally go is 8 oz. Mileage may vary.
- It doesn't take nearly as much pin material as you might think to properly start peening. A general rule of thumb here is 1mm above the surface and that's a pretty good rule. I believe jewelers go with a rule of "half the diameter of the pin material". In our case, that's generally ~1mm anyway.
- Get a proper anvil surface. It doesn't have to be an anvil per se, but think heavy, dense and metal. A bench block is good as is an anvil on a vise. A sledge hammer head is really good too. It'll make your peening efforts so much easier.
-
Just started a few mods myself. For the 91 I found it easiest to use my dremel with the jewelers? tip. It looks triangular. place the dremel on flat surface and introduce the knife to it. I got frustrated trying with drill press. Good luck.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login