TTi quality
-
So the pliers on my TTi rub pretty bad on the liners, one side worse than the other. I'm hesitant on sending it in for warranty as I don't want to get one back that will have the same problems.
The dates on mine are 0611 and 0711. So what do you think I should do, hold onto it or send it into Leatherman?
Sent from my HTC One using Tapatalk 4 Beta
-
Send it in. You can ask them to evaluate it and fix that particular unit. I have a 2007 era TTi. When new, it worked fine, except the pliers (when fully deployed) experienced some pretty bad friction and resistance when in use. They tips of the pliers did touch, but required considerable force to do so. Like grabbing an invisible pistachio.
I filled out the repair card (I think there was a repair card), wrote my letter describing the issue and asking them to address it, and received my TTi back 2 weeks later. It, the service and the tool, worked wonderfully.
-
Send that thing in! You pay top dollar on that tool and it should be 100% out of the box. Probably just slipped by final inspection somehow and I will bet they would be Halas to take care of it.

-
I would send it in. Leathermans customer service and warranties are better than anybody else.
-
Yeah, I think I might mail it in, or just wait till we go to Brampton ON in August and go to Eastern Outdoor Sales as they handle the warranty claims for Canada. It would be nice if I can just exchange it at the store, but I'm not sure how it would work.
-
Do you find that the diamond file also rubs the liners on the same tool? I know that is an issue that has been discussed here somewhere already, just curious if you have both issues in the same tool.
-
The file only rubs just a tiny bit, but not enough to worry about I don't think. I'm sure if I put a little pressure on it when it's open, it would bend just enough not to rub.
-
I have a Wave, so it's not the same but pretty comparable.
One side of it has much worse rubbing issues than the other. A bit of background: I have the file opposite my PE blade (same pivot), and the SE blade, which gets much less use, has a washer on the other side of the pivot so I can use the saw's space as storage. My PE blade over time has become progressively looser to there's about 2mm vertical (in the plane of the cut) blade play at the tip and that was really annoying me. On the other hand, the SE blade had a perfect lockup and not blade play at all. The file would tend to scrape a little bit if I didn't push it in whilst opening it, but because I tend to one hand open it like the knife that wasn't much of a problem to me.
I have now swapped the SE and the PE blades to improve the lockup of the PE blade, keeping the file on the same pivot as the PE blade (so same pivot, same tools, different handle). The lockup on the blade is now spot on, the file doesn't scrap at all but the SE blade has developed serious scraping issues. If I do the pivot screws up really tightly it will go in to the slot OK but anything else and the tip hits the side wall of the slot.
So, I don't the the problem is the file or the pivot, more likely the stamping of the handle or the cutting of the pivot holes.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login