Wave wire stripper
-
I just watched this YouTube video about the wave wire stripper
http://m.youtube.com/watch?v=2eP6Xl48Uy8
I'm using a wave with an unused and sharp stripper but I can't get it to cut the plastic insulation on the wire like this guy can. Maybe it's a different kind of wire over here in the UK .
How do you guys get on with it ? Seems easier with the knife blade
-
I never use it.
I usually use the wire cutters' hard wire notch for smaller ones, or the blade for larger ones. The harder and less flexible the insulation is, the better the wire stripper on the can opener works. If you've got what I know as conduit wire it works passably, a bit like in the video. I've never managed to sensibly do flex with it. -
I tried it a couple of times but I still prefer the knife blade. I think I have much more control with it not to ct the wire inside. Not a problem with such thick wire he's using, but on thinner, stranded wire, it's not as easy to do with that wire stripper notch.
-
I've used that V notch loads, works well IMO especially on thinner wires (I tend to cut through them when using a blade
which does nothing for the blade or the wire
)
I've used it on the wave & rebar (exactly the same 'tool part') and on a wingman.
I do miss it if wiring a ''3 pin plug" armed with a SAK*edit~
my 'method' is slightly different, it's more of a dig it in and pull in one motion (if that makes sense?) -
that's how I've tried to use it.
-
-
I've used it a couple of times with decent outcome. I never use the main blade to do these tasks, i fear i'll lose control and cut myself, i usually do this kind of things with a MT in tight places on board and i prefer not to take the wave blade out, it has some serious pointy tip!

-
I use it a lot at work ,i usually press the plastic case against the stripper and twist it to remove what i need of works ok for me

-
:-[
that's how I've tried to use it.
Are you saying you use just the wire stripper or the blade and stripper ?
@Taxi Dad said:
my 'method' is slightly different, it's more of a dig it in and pull in one motion (if that makes sense?)I've just tried this on a piece of 0.2mm flex. It's stripped the sheath of on one side but not the other and it's damaged the conductor. It's less rubbish on the 0.75mm flex, stripping the sheath but still damaging the conductors. If you don't press so hard it needs two attempts.
-
Can't speak to the Wave wire stripper specifically, but I always grab my ES4 if I think I will need to strip wires.
-
it seems the particular wire I was trying to strip had a very hard plastic insulation sleeve. I tried on some different wire and it worked a lot better.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login