Case Hardening
-
Case hardening: http://en.wikipedia.org/wiki/Case_hardening
has long held a certain fascination for me, perhaps because of the visible marks it leaves on metal surfaces.It would seem to offer some advantages to a tool designer over common homogenous steel. A tougher, higher yield strength inner core surrounded by an outer (1 to 2 mm thick) layer of much harder steel for better wear resistance.
The Wikipedia article says nowadays it is used on firing pins, rifle bolt faces, and camshafts. I'm guessing it would be too expensive to use for multitool implements. Still, it might be advantageous for implements where both high toughness and high surface hardness are desired.
Anyone know of any manufacturer that uses case hardening for tools or knives?
.
-
harley davidson engines have spme .100" deep hardenings,it aint much but its enough in crank pins that carry a s__tload of pressure and massive forces,i bet in tol industry u dont have to go even that deep.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login