Surge issue
-
Hi guys,
Newish New Surge owner here. I have an issue with mine where the can/bottle opener and the driver bit exchanger are extremely loose i.e gravity movable on some angles but they're ridiculously tight when moving past each other. The bit exchanger even seems spring loaded sort of like a Swiss Army Knife depending on where the opener is. Any ideas what I can do about it?I bought internationally so I'd like to fix this myself if possible. I bought a Wave as well and the safety catch on the blade popped out when I first opened it but I was able to repair that myself by buying a rivet tool and popping in the smallest size rivet and it's good as what new should have been now + I get to keep the rivet tool :)
Thanks
-
Welcome to mto
You can get a security type hex driver to tighten it but forget the size, you will need 2,i wish lm would sort there QC out :-\ -
You'll need one T10H for the Original Surge (one side is keyed) and two for the Surge.
Heat fastener with lighter to loosen the loctite if needed.
I had a similar issue, solved by putting a slightly thicker washer between them.
Try giving the parts a quick sanding first though and work in a drop of oil before tightening up the fastener.
Welcome to the forum.
-
Re the spring loaded comment.
If it is loose enough and the opener wasn't in the way then the sprung locking tab could push on the driver.
Watch the locking tab where it contacts the tool while opening and closing. Hope that makes sense.
-
Thanks guys. I do have the right size security torx but not 2 :( I am however in the fortunate position that I have 3 New Surges to compare side by side :)
I think I get what you mean about the spring loaded lock pushing and transferring the spring force to the loose driver exchanger to make it close down from near closed.
Since I can compare them visually it looks to me like the exchanger is off on a slight angle which would explain why it gets virtually stuck passing by the can opener. Either it's made wrong or perhaps the tighten is all it needs to bring it back to parallel. I'll try and post a photo to illustrate shortly
-
Here's the image I put together. Can you guess which one has the problem? Yeah the photo's not lined up the best but the fact that the base of the exchanger looks further to the right than the tip of the bit is the main thing. I tried to line up the bit tip with the middle of the plier mould and ended up slightly rotating the resulting pics on the pc so the mould line is vertical.

-
G'Day Mate,
Zen Imports (Ozz LM agents) will look after you, and have a fantastic customer service reputation. They do not worry weather the Tool was not purchased in Australia. I have had a couple of tools that they fixed / serviced that was purchased in South Africa, USA and the UK - no questions asked.
If you are in Sydney, I have 2 Torx bits you are welcome to use if you want to try tightening it yourself. I have done it without any problems.
Oh yes, welcome to the forum.
Pete
Zen Imports Pty Ltd
Unit 8
7-9 Rhodes St
West Ryde NSW 2114(02) 8878 3600
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login