Flashlight Pics
-
It is actually easier than I stated above. Just separate into two halves first. This is the part that has loctite, so some torque and maybe some heat will be required. If heat is needed, put the head in a thick plastic bag and suspend in hot (near boiling) water for a bit. I don't recommend that you use any type of plier or vice to unscrew the head.

Then, use a pair of small needle-nose pliers or snapring pliers in the two holes shown to unscrew the reflector:

Try not to let the glass window drop out to avoid fingerprints.
-

Specifications $59.00 on closeout at LA Police Gear
-
Thanks for the pics Terry. I might do the swapping of the reflectors after I can find a flat rubber tourniquet. I am hesitant to heat the head my emerging it in hot water. I will try first heating it by blowing hot air from hair drier. Will give you some update later.
Nice looking flashlight geodtech. Does it have the same workmanship and overall quality as SFs?
-
@edap617 said:
Thanks for the pics Terry. I might do the swapping of the reflectors after I can find a flat rubber tourniquet. I am hesitant to heat the head my emerging it in hot water. I will try first heating it by blowing hot air from hair drier. Will give you some update later.The hair dryer is a good way to start. You might also try using some small strap wrenches if you have them. I've attached an image of a strap wrench.
One thing I just thought about. You should try separating the two pieces of the head while the head is attached to the flashlight body. This should eliminate the possibility of deforming the threaded section of the head.

-
I've tried everything, strap wrenches, rubber bands, mole wrenches, freezing/boiling, nothing works on my P3D. :(
-
Thanks for the tips Terry.
jzmtl, did you also intend to change the replector of your P3D?
-
Solid as a tank

-

:D
-
My L1D at the park



Roots of acacia tree





-
I'll bite :) What's the one in the middle?
Neil
-
You can't pull the wool over your eyes Ryan mate.
-
It´s a Fenix E01 mini,
same output as the stock version,
one button cell Renata 357 (1,5 V, 190 mAh)
runtime approx. 1,5 h regulated. -
Energie has all the coolest lights!

Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login

:D