111 vs 91 saw mod question
-
Is the saw from a 111mm slide lock (not liner lock) the same thickness as the saw from a 91mm? Do they have a compatible pin location? I'm trying to make a custom tool for a 91 and I'm thinking of cutting down a 111 sl saw, but I want to confirm that it's a "drop in" swap in the sense that I can reuse the 91's backspring and don't have to mess with the pivots.
-
Since there are no answers here I try to help as best as I can:
I can only compare a 93mm saw and a 111mm linerlock saw: While the blades have the same thickness (the milled part), the pivot parts have different thicknesses and seem to have a different geometry. :-\ Looks like some filework would be needed.
I hope some wiser member comes by and can help you with the 'correct' saws!
May I ask what tool you like to make? I was once contemplatin grinding the saw of a Hunter XT into a Marlin spike to have a knife for ropework. Just a silly idea, I have never tried anything like that.
-
Yeah, AFAIK 91mm and 111mm slide-locks have 2.5mm pivot pins on the ends, whereas 93mm and 111mm liner-locks have 3.0mm end pins. <s>It's good to hear that they're the same thickness though, that means 91 and 111sl's are probably the same too.</s> Wait, I read that wrong- the end part of the tool that the pivot pin passes through are <i>not</i> the same thickness?
I was thinking of making a combination long-neck screwdriver / marlin spike. I have an old 111 with a saw and I ground the tip into a phillips point, and found that it could handle a surprising amount of torque. I'm not sure how much material I can remove before it gets too flexy though.
-
If you need any i have alot of brand new 91 mm saws . I can send you some for the cost of shipping.
-
@Syph007 said:
If you need any i have alot of brand new 91 mm saws . I can send you some for the cost of shipping.I think I asked you about something similar several months ago but with fishscalers or something. You're in canada, right? I'm on the US east coast, I seem to recall that shipping/tariffs/etc made mailing small stuff not really worth it. What would it cost to get something from where you are to here?
I'm also not sure that I can do what I want with a 91 saw. I'll need to carve down the tip into a screwdriver point, and AFAIK the overhanging tip is how you open the thing. I figured I'd need something longer than 91 to start, which is why I was thinking swipe the saw from a 111 slide lock (assuming the pivot-pin end of a 111 sl saw can fit into a 91 without messing around).
-
@Quartz said:
<s>It's good to hear that they're the same thickness though, that means 91 and 111sl's are probably the same too.</s> Wait, I read that wrong- the end part of the tool that the pivot pin passes through are <i>not</i> the same thickness?Sorry for answering only today. Yes, that was what I meant: The pivot part has a different width on those models. Sorry for the confusion.

-
As a side note, I think maybe I posted this in the wrong section. I can't believe there's nobody on this forum who owns both a 91 and 111sl with saws.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login