Torque?
-
I wouldn't do anything that has a sharp tip. Such as the wave.
I super tool 300 (or rebar for smaller) has thicker heads. Either way, the week point is the pivots. And the only pivot avoidance is try an OHT or Gerber..........
-
Wave and Blast have the same pliers head.
Try to break them, you can always send them in for replacement.You have to try doing it with BlackTip, it flex so much I shoulkd call it bended tip.
-
I have broken off tips. Never broken a pivot, but definitely borked a few

-
Multitool pliers aren't designed for heavy use. Buy a dedicated tool for that stuff. Even the big boys like the SwissTool or ST300 aren't going to be adequate for truly heavy duty use. No way.
Frankly, my multitool pliers are great for being a grabby thing. Other than that.....YMMVSent from my iPhone using Tapatalk
-
I second the Surge :). I carry a first gen Surge and have yet to break the pliers despite heavy use, as well as twisting some pretty stout stuff. Love my Surge!!
-
Even the st300 handles will flex a bit when you squeeze them hard. They are hollow because of the tools.
-
We might need a little more detail OP.....
Are we talking always bending coat hangers? Or are you also molding 3/8" rebar [emoji14]
-
Thanks for the replies. I think I may have been expecting too much from a multitool. I do however get a lot of use out of mine and very much enjoy using them.
Will look into the surge or possibly a SOG.
-
Leatherman tools are going to flex under load for a number of reasons.
First, there's the steel. Leatherman makes their tools from 420HC, a stainless blade steel designed for high corrosion resistance and toughness (not necessarily hardness or rigidity). You don't want a very rigid knife blade because it could easily snap, so 400 series stainless steels have some spring-like flex to them. The handles are punched from sheet steel, the pliers are cast and machined.
Then there's the construction of the chassis. A classic Leatherman tool like the Blast has handles that are stamped from sheet steel and bent in a press brake into a U channel, the Juice line is built up from backsprings and separator plates like a Swiss army knife. Both of these designs will twist and flex under load. Airplane wings are built in a similar way.
Normal toolbox pliers on the other hand are made of drop forged vanadium steel, which is much harder and less flexible. The jaws and handles are normally cast as single pieces that are riveted or bolted together at the joint. They're more rigid both in alloy and in structure. Most regular pliers aren't stainless, so they will corrode unless coated or plated.
The hardest I've ever squeezed something with Leatherman pliers was hard wire cutting. You can squeeze a Leatherman tool hard enough to cut a 16d framing nail without fear of damaging the tool. I've done it with my Skeletool, which has similar pliers to the Juice. If I have to squeeze it harder than that, I go and get a pair of channellocks or a bench vise.
-
I agree. It's not the squeezing that damages them, it's when you have to twist something that Leatherman pliers have troubles.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login