Skip to content
Collapse
? [[global:guest]]
Unread Recent
HOME SEARCH PROFILE MESSAGES 0 BOOKMARKS MEMBERS BADGES
Multitool.Org Forum
MultiTool.org • Community Header Space • Watch This Space

Vic Microlight Question (resolved)

Scheduled Pinned Locked Moved Flashlight Forum
2 Posts 1 Posters 1.4k Views
  1. Home
  2. Non Tool Forum
  3. Flashlight Forum
  4. Vic Microlight Question (resolved)
Vic Microlight Question (resolved)
  • Oldest to Newest
  • Newest to Oldest
  • Most Votes
Reply
  • Reply as topic
Log in to reply
This topic has been deleted. Only users with topic management privileges can see it.
  • Rodion Offline
    Rodion
    Posts: 744
    Rodion Offline
    Rodion
    wrote on last edited by Rodion
    Quote Reply

      As I've mentioned before, the Photon Freedom I love and cherish so broke down. Sort of. It still works, but the LED has a tendency to fall out from impact. Yikes. I've used this as an excuse to splurge on the proverbial Victorinox microlight. Not a week later, it's here. Unfortunately, it came without instructions. In my case, that's bad. The Vic website says it's got 4 modes. I've seen Inova microlights before and they definitely have at least 2. However, I cannot seem to get anything out of mine but momentary on. There's no slide switch on the bottom as with normal Inova microlights, either. I'm stumped. Can anyone explain???

      P.S. I cannot send the Freedom in for a warranty claim because of the embarrassing nature of its malfunctions.

      P.P.S. No, I did not use it to assist a colonoscopy. >:(

      Okay, I'm half-way there: apparently, holding the button down for 30 seconds takes the light from "signal" mode to "normal". That is, clicking once brings you to "high" mode, clicking twice brings you to "low" mode and a third click turns on the strobe.

      Unfortunately, I can not get back to "signal" mode. Oh well, one breakthroughat a time...

      Well, since I already started the thread: light is much larger than a Photon, borderline keychainable if you swap the clip for a little ring (huge pain in the rear, had to use tweezers and small pliers to accomplish this). Beam looks very bright and clean, though I can't compare with a white Photon (only have a red one). Body feels a bit "rubbery", don't know how it'll hold up. Provided it does, the light looks sturdier than the above Photon. Changing the battery is approximately as simple.

      1 Reply Last reply
      • billytex1 Offline
        billytex1
        Posts: 1
        billytex1 Offline
        billytex1
        wrote on last edited by
        #1 Quote Reply

          Figured it out!! The microlight is shipped in 'signal' mode (momentary on, only as long as you hold the button down) - probably as discussed to keep folks from turning it on thru the packaging and running the batteries down before it's sold.

          To switch to 'normal' mode, hold the button down as described for about 20 seconds - the light will stay on all the time you hold the button down - then go off even though you're still holding the button down.

          NOW it's in high/low/strobe mode. Push the button once, it's on constant in 'high'. Push it again, it goes to 'low'. Push it again, it goes to 'strobe'. Push it again, it goes 'off'.

          Here's the trick to get back to 'signal' or 'momentary' - with the light in this mode, cycle through high, low, and strobe, and when you push it with it in 'strobe' to take it to 'off', HOLD IT DOWN and don't let go - light will go 'off' (because you pushed the button to take it out of 'strobe'), then when it's reset itself to 'signal', the light will BLINK FOUR TIMES FAST at you telling you it's reset back to 'signal' or 'momentary'.

          enjoy!

          1 Reply Last reply

          Hello! It looks like you're interested in this conversation, but you don't have an account yet.

          Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.

          With your input, this post could be even better 💗

          Register Login

          1. Home
          2. Non Tool Forum
          3. Flashlight Forum
          4. Vic Microlight Question (resolved)
          Reply
          • Reply as topic
          Log in to reply
          COMMUNITY LINKS
          EDC-TV SAKWiki GearFeed SAKSelector
          Operational Funds

          Help us keep the Unworkable working!

          Make A Donation
          November Goal: $300.00
          Due Date: Nov 30
          Total Receipts: $0.00
          Below Goal: $300.00
          0% funded
          • Login

          • Don't have an account? Register

          • Login or register to search.
          • First post
            Last post
          0