Micra Scissor Problem
-
Yesterday, I bought myself a new Micra, my first. Unfortunately, the rivet holding the two blades of the scissors together is extremely loose, and it has lots of side-to-side play. It'll still cut, just not anything thin like cellophane snack cake wrappers or Scotch tape.
Is there any way to tighten it up without having to spend $10 to send it in on warranty?
-
Hammer.
-
A dozen or more gentle taps with a small ball peen, is better than a couple heavy wacks.
Go slow.

-
Hammer and a Pin punch.
Here's how I do it on pliers.
/post/1283754
-
Sorry for digging up this old thread.
I have a micra which is extremely old, more than 20 years. It holds a lot of sentimental value for me. Following instructions here to tighten the rivet as well as instructions elsewhere to sharpen the pair of scissors, I managed to get it to cut paper very well. However it will not cut thin plastic bags, just slips through. I'm beginning to wonder whether it can be sharpened to cut plastic bags or did it work on these in the first place. Advise needed so I know whether I should still be trying to sharpen it. Thanks in advance!
JJ
** the scissors had been through a lot of tough work throughout the 20 years

-
Cool diggin'
Most my Micra do cut thin plastic bags
Make sure blades are crossing each other from start to endBut honestly, I wouldn't risk ruining them
-
with m47
since you have had them so long and they do cut I wouldn't risk over sharpening them :ahhhAlso welcome to
ruriimasu 
-
(do it the MTo way : buy a new one and keep the old as a shelf queen)
-
Thoroughly clean and oil it.
-
@m47mu74nt said:
(do it the MTo way : buy a new one and keep the old as a shelf queen)+1.
-
I have quite a lot of multitools. But I just like to EDC this particular tool so I can be reminded of this person whenever I used it. =)
JJ
@m47mu74nt said:
(do it the MTo way : buy a new one and keep the old as a shelf queen) -
Guess I'll try more sharpening. Thanks for confirming this.
JJ
@m47mu74nt said:
Cool diggin'Most my Micra do cut thin plastic bags
Make sure blades are crossing each other from start to endBut honestly, I wouldn't risk ruining them
-
@ruriimasu said:
I just like to EDC this particular tool so I can be reminded of this person whenever I used it.Ah, sentimental value. I understand perfectly.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login