Crunch bit attachment hole
-
Any way for LEATHERMAN to put on the bit attachment hole on the crunch to other models. I have a PULSE which I cant divorce even though I have a WAVE and ES4. I would pay Leatherman to send it back and retro fit it with the hole. Not a fan of the wave attachments.
Also Crunch folks ,are you able to do fine needle nose work with the Crunch end like grab a thin wire and wrap it ?
Thanks -
Welcome to

I don't think LM will cut the hole but you might try the mod forum and see if a modder could do this

-
Welcome to the boards mate.
Bit driver would have to be DIY. Also fine tasks are no problem for the Crunch. -
If you fully remove the adjustment screw on the Crunch you will find a 1/2" hex hole that fits the Leatherman bit extender and bits. Pretty handy!
-
Oops....didn't read carefully enough. The OP was asking about adding a bit hole on models other than the Crunch. My bad!
-
Yes reto fit a Pulse with the bit connector blade from Wave or even better cut the same hole the Crunch has to put a bit in the screw bolt. Thanks
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login