My custom wave
-
@386greene said:
The top key was actually nice and easy. It opens with one hand and locks up nicely.Really need to cut a new key for the bottom, I shaved that key down which I previously had with the internal tools and there wasn't really enough material to make a catch to open it
And the inside of the cap part is still rough, need to finish it up, it's basically just a spacer for looks. There's nothing to lock the key open, but I think I could make some slots in the frame and make a new liner lock for it. Not sure if that will weaken the frame though.
Very cool

-
So here's an update.
Added the 3d Phillips since it has better reach for small electronics, and a dedicated flat so I could put a torx bit in the bit holder. I did remove the plier rests inside the frame, just snapped it off and ground it flat to keep the springs and locks. Also, put a notch in the frame for the bottom key and cleaned it up some, put some washers on it and got the right torque on the pivot. Nice and smooth operationI'm pretty happy with it for now (put locktite on the pivots) so I'm leaving it for a while. Don't think I'm going to pursue the strippers or punchdown tool for a while. Plus, I'm gonna start on my wife's new juice here tonight lol


-
Very nice

Sent on my SM-G930F with Tapatalk
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login