Durable brass lacquer?
-
I’ve only made one set of scales for a 93mm. I didn’t go to high of grit on the handsanding because I had to rush it because I needed the alox scales as a template for another more pressing build. I did polish it but I haven’t sealed it I’ll have to look in to the finishing process a bit more. As far as thinness, you can run really thin carbon fiber scales, however when your using scale tools the constraint isn’t the carbon fiber it’s the thickness of the scale tools themselves. The scales I have on my 93mm or thinner than the 93mm alox but slightly thicker than the 84mm alox scales.
-
Your picture attachment doesn't seem to work for me

-
Let’s try this again, silly file size limit... apparently I can’t crop this photo small enough on my phone to post it. Let me see if I can get an Instagram link.
-
https://instagram.com/p/Bo72TQKBscS/ one of these will work
-
I’m sure you already have a solution, but I’ve never been able to stop verdigris forming on brass that is in contact with tanned leather on my cartridge belts. I know you are looking for protective finishes on the bolsters, just be sure to use it on the back side too as I’ve had the verdigris form inside empty cartridges that aren’t in direct contact with the leather.

Sent from my iPad using Tapatalk
-
Indeed. I intent to be making leather pouches to carry them in, but don't plan on storing them in there. As verdigris is just brass "rusting" or oxidising, and doesn't need to be in contact with leather for that to happen, I want knives in storage to be visible, so if I go in the drawer and spot a hint of green, I'll be prompted to do something about it. I've had a few other items be hit with a little verdigris from time to time, but not bad, and thankfully didn't take too much elbow grease to sort it out.
-
Carbon fibre is pretty easy to work with, but needs very sharp tools IME. Use blunt drills and you'll tear the fibres out of the resin. If you're sanding, do it wet or outside, or use a mask. The dust is horrible (same for G10, micarta, etc.).
-
@Simyo said:
https://instagram.com/p/Bo72TQKBscS/ one of these will work
-
@hiraethus said:
Carbon fibre is pretty easy to work with, but needs very sharp tools IME. Use blunt drills and you'll tear the fibres out of the resin. If you're sanding, do it wet or outside, or use a mask. The dust is horrible (same for G10, micarta, etc.).Cheers Chris

Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login