SAK mod grinding problem
-
I'm just in the process of doing my first SAK mod, which I'll be unveiling in the near future. Needless to say I've got a little adventurous by not just playing with layers...

However I have one slight problem - one of my tools seems to grind when opening and closing, and on closer inspection it seems the tang of said tool is creating a groove in the back spring. Could this be because there's too much tension and the spring is pushing to hard on the tang? If so, could grinding a tiny bit away from the spring surface help (to flatten the spring surface again) to reduce tension, and also the tang?
Really excited about this first mod but I just seem to be stumped on this little hurdle!
Any advise greatly appreciated

-
Are those standard spring and tools? You can just bend the backspring a but to reduce tension... also sand and polish the burs of the contact surfaces for smooth opening...
-
Did you grind on either spring or tool? If so they probably got too hot and got annealed and lost its hardness. That's been the cause of all issues like that for me. So either figure out how to heat treat it again or just start over with new part.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login