Awls
-
Hi all,
Would someone mind posting detailed pics of all angles of awls from alox soldiers and vintage cellidor models please?
I'm wondering if I can try making some from can openers to try to fit opposite a main blade on a 91mm form factor but I don't have any to model one on and don't know fully what they look like!
Thanks very much
-
Wenger soldier '88






[It's not failure if you learn something from it]
-
Awl of them?

-
@ReamerPunch said:
Awl of them?
Awl, come on! :D
-
That's awl the soldiers I have!
[It's not failure if you learn something from it]
-
From an '03:
I think you need a 'head-on' shot to see it.




I think they are a break-shape from sheetmetal stock.
By 'vintage', do you mean the pre-'61 'triangular' or conical ones? They're thick. Measured one at 5.2mm wide.
-
Any and all shapes please... Im investigating which might be the easiest one to make, if any!
-
@ReamerPunch said:
Awl of them?
As awlways, we'll have to put up with some awlful puns...
-
Yes, awlfully sorry about that....
-
Hi craggus2000
The awl’s shape is quite complex. The awl ‘blade’ edge would be easy to reproduce as it’s straight and a single chisel grind. My Alox Pioneers all have a taper grind in the last 3mm to give a needle point.
I think the problem you may have is the spine. While the blade thickness (at the pivot) is 1.80mm the spine rolls over making the total thickness 3.45mm. This rolled spine stays outside the scale and forms the nail nick. My opener is only 2.29mm thick so there’s not enough meat on the tool to reshape into the awl, and it’s too short. You’d have to start with a fresh billet and machine it.
Will be a fun project whatever you decide!





-
vintage cellidor Wenger



Sent from my SM-N950U using Tapatalk
-
A couple more Wenger awls, and a leather punch:

Sent from my SM-N950U using Tapatalk
-
@AndyTiedye said:
A couple more Wenger awls, and a leather punch:
Sent from my SM-N950U using Tapatalk
- Never seen these before!

- Never seen these before!
-
The can opener uses the curved hook part to stop the tool from dropping too far down into the knife when closed. You need to be careful not to cut too much off this bit or you won't be able to access the nail nick.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login