Remove etching/engraving
-
I had some Learhermans bougjt second hand with engravings on them. Some deeper and some lighter.
I used sandpaper, 800grit and upper and than slight polish. Either way, you will remove the engraving yet the finish will not be the same as from factory, just so you know -
Hmmm, hoped to get it off with some 'soap' like stuff (I have no idea how to say that in English).
Grinding is not an option… -
400 grit Sandpaper followed by finer to match the finish. Sand in straight lines following the factory finish. I did this with a LM Mini that I got and you can't tell there was a logo ever there.
-
@SteveC said:
400 grit Sandpaper followed by finer to match the finish. Sand in straight lines following the factory finish. I did this with a LM Mini that I got and you can't tell there was a logo ever there.
You could also use a bit of polishing compound at the same time to speed it up... If you can't get something like Autosol, anything that you can use to clean a ss sink will work... even tooth paste, but that will be sticky... and minty... it does work though.Btw, it's been laser'd on, so it won't scrape off.
-
Hmmm, that'll be a summer project. Also have to find the right paper.
-
Steel wool might be an option. I use the extra fine type for fading black oxide. You may need at least a medium grade though.
-
Hey Serena keep us posted on this, I'm interested on what you come up with, thanks

-
Dremel at low speed with a sanding disc. Follow by 800grit sand paper by hand. Works fast and easiest.
-
@genevabuck said:
Steel wool might be an option. I use the extra fine type for fading black oxide. You may need at least a medium grade though.
I spend a good deal of time making BO finishes darker and more even. I may have a problem.
@SteveC said:
400 grit Sandpaper followed by finer to match the finish. Sand in straight lines following the factory finish. I did this with a LM Mini that I got and you can't tell there was a logo ever there.This.

@Fuzzbucket said:
You could also use a bit of polishing compound at the same time to speed it up... If you can't get something like Autosol, anything that you can use to clean a ss sink will work... even tooth paste, but that will be sticky... and minty... it does work though.Btw, it's been laser'd on, so it won't scrape off.
This.

@Sam Lim said:
Dremel at low speed with a sanding disc. Follow by 800grit sand paper by hand. Works fast and easiest.And this.

Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
