Cleaning a multi
-
Funnily enough I’m just about to start cleaning a LM Pulse Steve.
Will be using mostly WD40, a brass bristle wire brush and on any really stubborn rust some rust remover.
Once cleaned up will use some Vic knife oil on the joints and a thin coat of mineral oil. Have had great success on some pretty poor condition knives and MT’s with this method in the past
This one’s not too bad but have cleaned some really poor ones like this


-
I normally remove rust from things like old axe heads by soaking in vinegar. It didn't remove much off an MP400 I cleaned up.
As far as damaging the finish, perhaps I did? Bear in mind that the rust has already damaged the surface. -
I use Evapo-rust liquid to remove rust from things, especially from hand tools. It contains no harmful chemicals.
-
So these methods have not damaged the surface finish? I know rust spots will but I don’t want spots on a nice multi
Not sure about evaporust? I’ve used that and it works great but it also darkens the steel. -
Vinegar will eat away at the surface if left too long, but then I wouldn't use it again just for spots of rust.
Sandpaper will scratch so the finer the better. -
what sort of finish are talking about? If it's rusted, then your finish is already damaged. shrugs
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login