Openers/Awl layer weaker spring
-
Haven’t noticed that specifically. The opener spring is not much different than the blades spring with the corkscrew/Phillips. One factor that may affect a perceived difference is that the tools are shorter and don’t have as much mass thus closing with less force. The small blade generally doesn’t snap as hard as the main blade for this reason. Of course the tolerance of the ground shape of the tangs also effects this due to providing greater resistance, pent up kinetic energy which translates into a faster, snappier close once they pass the break angle. Usually the main blade gets weaker over years from more use and wear. Unless the closing is terribly weak I don’t worry about it. Modern Wengers generally had a smoother, less snappy action by design comparatively.
-
Also notice than when I have the screwdriver opened, the awl snaps harder closing. I think the impact is smoothed or something by the tool in front.
-
I had a new 111mm Adventurer with a can opener that had very weak closing action. I recently sent it to Victorinox for repair, and after paying a $5 handling fee, and a 3 week wait, I got it back. I can’t say for sure whether it’s the same one I sent in, or if they repaired it. I also recently sent in a Craftsman that had weak closing backside tools, but it hasn’t returned yet. I do have a few that have weak closing tools when they get dirty or need some oil.
-
OIL BABY. They now snap.
-
This leads me to the question: from how much time to time do you fellows oil your saks?
-
As needed, I’ve bought some 40 year old new unused SAKs that have tools with no oil and a strong snap, and some are dependent on oil to function properly. Most of the ones I carry will need a cleaning every month or two, depending on the amount of lint and dirt accumulated.
-
I also oil as needed. Known or suspected intrusion of water into the pivot points is one case that merits an oiling.
-
I have a 30 year old Tinker (now retired to desk duty) that has no snap at all on any blade/tool except the screw driver. Washed, cleaned and oiled, no snap. Got a new Tinker a few years ago that is good. Tinker's rule!
-
@Rich S said:
I have a 30 year old Tinker (now retired to desk duty) that has no snap at all on any blade/tool except the screw driver. Washed, cleaned and oiled, no snap. Got a new Tinker a few years ago that is good. Tinker's rule!Congratulations on using a SAK so solidly that it couldnt go on any further and full marks for promptly getting another

Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
