cap crimper modification
-
Not that i would but could you make your non cap crimper multi into a cap crimper using maybe a drill that lubes the drillbit? That way heat wouldn't weaken the pliers. Wonder if there is any difference in plier heads from the factory or would they just do what i mentioned above to create a cap crimper.
-
Sounds tricky to me. Most of the cap crimpers I have aren't simple holes drilled through, there's a "flashing" halfway through. I suppos eyou could drill to not quite half way from each side, but I think the factory models (LMs at least) might be cast that way. Not sure, but Bob might have some more insight.
-
@DaveK said:
Sounds tricky to me. Most of the cap crimpers I have aren't simple holes drilled through, there's a "flashing" halfway through. I suppos eyou could drill to not quite half way from each side, but I think the factory models (LMs at least) might be cast that way. Not sure, but Bob might have some more insight.Dave's exactly right, the factory ones are cast to size:


I suppose you could make your own, but it wouldn't be easy :-\
-
You would really have to hold the pliers together extremely tight and drill very very slow with a lot of oil
-
Good idea,but wouldn't try it,when of if it breaks,you will get no warranty work done on it. JMO

-
That sounds like a right PITA to do. :-\
-
I believe that that is the 1st pic I have seen of a cap crimper close up
Thanks :D
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login