Sharpening, discuss.
-
So there are a lot of different ways to sharpen your knives.
But the other question that should have been asked is how sharp do you make your knives.
Someone who is sharpening his knife with a strop wants it much sharper than someone who spends 20 seconds a week with a lansky sharpenIng kit.
Also blade steel is a big factor, softer steel gets touched up quick to razor sharpness and sv30 takes longer but holds that edge longer.I have a Swisstool so i have the regular SAK blade steel.
I dull my blade pretty quick because i sometimes cut material that is not supposed for a SAK blade. (Plastic bottles carpet etc..)
But most of the time bananas, apples, rope and i always cut the curry and mayo bottles open to get the last out.
I sharpen my knife once a week and do this on a cheap lansky sharpening system.
I make it hair popping sharp with the white ceramic rods.
I first Clean of all the gunk of the knife blade and then pull it about ten times over the lansky system.Then it is good for another week.

-
I've been on both sides of the fence with sharpening. I used to want all my knives surgical sharp then sharp enough now I'm back to hair popping sharp.
I enjoy the process as much as the results however removing steel is not something I take lightly. Stropping for me is a great way to keep my SAKs ready to go as well as my MT blade without shortening the life of the knife.
-
@Aloha007 said:
I've been on both sides of the fence with sharpening. I used to want all my knives surgical sharp then sharp enough now I'm back to hair popping sharp.I enjoy the process as much as the results however removing steel is not something I take lightly. Stropping for me is a great way to keep my SAKs ready to go as well as my MT blade without shortening the life of the knife.
Stropping is so easy, everyone should be doing it. If not for the sharpness of the blade, then the therauputic benefit of the act itself
-
@Luna Knife said:
I've been on both sides of the fence with sharpening. I used to want all my knives surgical sharp then sharp enough now I'm back to hair popping sharp.
I enjoy the process as much as the results however removing steel is not something I take lightly. Stropping for me is a great way to keep my SAKs ready to go as well as my MT blade without shortening the life of the knife.
Stropping is so easy, everyone should be doing it. If not for the sharpness of the blade, then the therauputic benefit of the act itself
Yes but you can also over do it and round over the edge. The same could be said about using deburring sticks (rounding over, actually dulling the new edge) and destressing the edge (it takes away a lot of metal and one should be adequate at sharpening and using low grit stones)
-
@Luna Knife said:
I've been on both sides of the fence with sharpening. I used to want all my knives surgical sharp then sharp enough now I'm back to hair popping sharp.
I enjoy the process as much as the results however removing steel is not something I take lightly. Stropping for me is a great way to keep my SAKs ready to go as well as my MT blade without shortening the life of the knife.
to overdo stropping it must take 1000 strokes. I do 15-20 max.
You can use leather, cardboard, denim or even your hairy arm
Stropping is so easy, everyone should be doing it. If not for the sharpness of the blade, then the therauputic benefit of the act itself
Yes but you can also over do it and round over the edge. The same could be said about using deburring sticks (rounding over, actually dulling the new edge) and destressing the edge (it takes away a lot of metal and one should be adequate at sharpening and using low grit stones)
-
We need kwakster here...
I also use the Sharpmaker. Its easy to use and gives great results.

-
I use a Young's (I think I got the brand right) pocket sharpener I got at an estate sale nib. It is primarily for arrow heads but also had a sharpener for knives.
-
@Luna Knife said:
I've been on both sides of the fence with sharpening. I used to want all my knives surgical sharp then sharp enough now I'm back to hair popping sharp.
I enjoy the process as much as the results however removing steel is not something I take lightly. Stropping for me is a great way to keep my SAKs ready to go as well as my MT blade without shortening the life of the knife.
Stropping is so easy, everyone should be doing it. If not for the sharpness of the blade, then the therauputic benefit of the act itself
Yes but you can also over do it and round over the edge. The same could be said about using deburring sticks (rounding over, actually dulling the new edge) and destressing the edge (it takes away a lot of metal and one should be adequate at sharpening and using low grit stones)
Very good points. I've rounded the edge when I first started stropping. I scratched my head wondering what happened. As with all sharpening patience and experience is key.
-
It depends on how dull the blade is.
-For a really dull blade, I use a diamond flat: coarse, then fine. Then, I use a crock stick (fine ceramic rod) to get it sharp. If I want it to pop hairs (for example, you don't want an axe or machete that sharp) then I strop it with the back side of a leather belt loaded with polishing compound. Finally, a strop on a glossy magazine cover gets it hair-popping.
-For a semi-sharp blade or just a touch-up, you can eliminate the first step or two, then proceed as I do.Everything is done freehand; no angle guides or machines. Most of my EDC blades have a 15-degree angle per side, but some go down to 10-degrees per side. Multi-tool blades are fine at 20-degrees per side.
-
@Luna Knife said:
@Luna Knife said:
I've been on both sides of the fence with sharpening. I used to want all my knives surgical sharp then sharp enough now I'm back to hair popping sharp.
I enjoy the process as much as the results however removing steel is not something I take lightly. Stropping for me is a great way to keep my SAKs ready to go as well as my MT blade without shortening the life of the knife.
Stropping is so easy, everyone should be doing it. If not for the sharpness of the blade, then the therauputic benefit of the act itself
Yes but you can also over do it and round over the edge. The same could be said about using deburring sticks (rounding over, actually dulling the new edge) and destressing the edge (it takes away a lot of metal and one should be adequate at sharpening and using low grit stones)
**to overdo stropping it must take 1000 strokes. I do 15-20 max.
You can use leather, cardboard, denim or even your hairy arm**
exactly. still there are individuals who are self proclaimed experts that spend hours on stropping and set that as an example.
as far as medium goes, leather and cardboard are my top choice. true you can do it on your arm, but after a few cuts, i'm simply not a fan
-
When you say Lansky system you need to be clear as there are a few.
The crock stick one, the clamp one etc.
I don't see the clamp one as a touch up sharpener, the sticks are for sure.Sent from my iPhone using Tapatalk
-
@shark_za said:
When you say Lansky system you need to be clear as there are a few.
The crock stick one, the clamp one etc.
I don't see the clamp one as a touch up sharpener, the sticks are for sure.Sent from my iPhone using Tapatalk
If I re-profile the edge I use the Lansky system that clamps to the blade, for touch ups I used the Lansky Turn box like Andi posted.
-
I ‘m in the extreme the in that I use an electric sharpener. I had my doubts, but the Chef's Choice 120 works really well. I run the knives through stages two and three, then follow up with a two or three feather-light passes with an accusharp hand sharpener. It takes less than 5 minutes and I get an edge that is hair-popping razor sharp. For really dull knives I give them a pass through stage one first. I sharpen the kitchen knives twice a year and they stay razor sharp.
I tip my hat to the sharpening gurus who get razor sharp edges from using ceramic mugs, car windows, or sharpening rods. All those methods require that you hold the knife at exactly the right angle, or they don’t work worth a poop. I’m just not that steady.
Me, I need an machine. And it’s easier for me to keep a sharp knife sharp rather than get a dull knife sharp. Don’t let your knives get dull. In the highly improbable instance where my knives get too dull for the machine, then I’ll have a professional sharpen them
The only things I sharpen by hand are my mora knives and scissors, because the bevel is big enough for me to follow accurately with a diamond sharpening card. Sharpening the scissors on a Swisstool Spirit is VERY easy since the bevel is so robust. All you have to do is pop the spring and that frees things up for sharpening.
-
Have many folks here tried stropping on very fine sandpaper? Like 2000 grit?
I ask because I don't have a leather or canvas strop, and i DO have very high grit sandpaper, and thought I might give it a try.
-
@Lynn LeFey said:
Have many folks here tried stropping on very fine sandpaper? Like 2000 grit?I ask because I don't have a leather or canvas strop, and i DO have very high grit sandpaper, and thought I might give it a try.
I have gone the other way and used rough sandpaper glued to a board to set a bevel.
There is a place that sells a great loaded strop on a board for like 20 bucks. When I get home I will post up a link.
-
@Lynn LeFey said:
Have many folks here tried stropping on very fine sandpaper? Like 2000 grit?I ask because I don't have a leather or canvas strop, and i DO have very high grit sandpaper, and thought I might give it a try.
Yes, Ive used some 1500 grit with good results. I've also used 400 grit to sharpen first then the 1500 to stop and then onto a leather strop.
-
I've not tried it however I have used various grits up to 2000 to sharpen my hatchets with great results.
https://www.youtube.com/watch?v=UOMzx2bJpHg -
When I use wet and dry sandpaper to sharpen knifes I wet a price of glass and put the sand paper on it. The water holds sandpaper in place and the glass makes a good base to sharpen on.
Sent from my iPhone using Tapatalk
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login

