Any mechanics here?
-
It gives a wide choice in the owners manual
20w-50
15w-40 15w-50
10w-40 10w-50
10w- 30. "Preferred" it says
5w-30Then states be sure to use oil under quality classification
SE, SF, SG, SH, SJ and SL
I've no idea what any of that means
-
Hmm tricky, I would go for the preferred option and then do an oil and filer change
-
The filling station is nearby
Shall I go and grab a litre of 10w-30 semi synthetic
Just wondered if that would cover in case its got either mineral, synthetic or semi synthetic already in.
Typically Sunday

-
If it's not bellow the minimum mark on the dipstick then I wouldn't panic. If it is then top it up with anything and then change the oil and filter at the weekend
-
@tosh said:
OK, just been onto Halfords website......3 recommendations:-
10x40 part synthetic
10x40
5x30
I don't want to put the wrong stuff in, nor do I want to drain and refill without replacing the oil filter!
What would the garage do if someone just pulled up and asked for a top up?
It must happen all the time, how do they know what's already in??
Would it be safe to add half a litre of 10w40?? (What's the difference between oil designed for diesel engines and petrol engines?
10W40 part syntethic is a good choice for regular use.
10W40 synth is the better variant if you often do short drives (many cold starts)
5W30 synth is usually the choice for elongated service intervalsI´d say, don´t top off until above Min., if you do, use one of the aforementioned. Worst that can happe is that the oil will be "downgraded" to the least quality in the mix, which still is in spec for your car. All of todays engine oils can be mixed with each other (Rizinus based oils aside), the only negative effect is that all the oil will tend to behaved like the cheapest/least additivated.
Diesel/petrol oils have different additives, the Diesel has more additives to keep small particles afloat while the petrol oil has additives to withstand thinning by petrol and alkalic remnants from the burning process.
I can answer longer and more elaborated tomorrow, but need to hop under the shower and into my bed now.
-
Thanks to everyone for their advice.
I did finally drive to the filling station and purchased a litre of 10W-40 Castrol GTX semi synthetic
I couldn't believe it when it consumed almost the entire bottle to bring the level between min & max on the dipstick.
I'm concerned the level was so low. It had been stood for almost 3 months prior to us purchasing it and going by the MOT certificate has done less than 300 miles since last November.
I did check under the engine for oil leaks and was pretty taken aback that there was absolutely no sign of any oil anywhere!! Coolant level seems correct, it doesn't smoke, pulls really well for such an old small car and just drives sweet.So, why the low oil level?? Alarm bells are ringing!!
-
@tosh said:
So, why the low oil level?? Alarm bells are ringing!!It might not have been filled up past the minimum last time oil was added.
I wouldn't start panicking just yet. Just monitor the oil level for a while to see what is happening.
One thing to remember is if a vehicle is mainly driven on short trips where the engine doesn't get properly warmed up for an extended time, then water can condense in the oil, raising the level shown on the dipstick. If you then go for longer drive at highway speeds these condensates can get boiled off and the oil level can suddenly drop.
-
So, why the low oil level?? Alarm bells are ringing!!
It might not have been filled up past the minimum last time oil was added.
**I wouldn't start panicking just yet. Just monitor the oil level for a while to see what is happening. **
One thing to remember is if a vehicle is mainly driven on short trips where the engine doesn't get properly warmed up for an extended time, then water can condense in the oil, raising the level shown on the dipstick. If you then go for longer drive at highway speeds these condensates can get boiled off and the oil level can suddenly drop.
Don't worry to much if you are not noticing any signs of damage. Keep a close eye on the oil level. I would just do a proper oil change (and filter) and keep monitoring regularly to see exactly what is going on. When you do the first oil change you will need to decide what exact oil you will want to use for the future of the car.
-
I've been I mechanic for 13 yrs. As others have said any oil is better than no oil. 10w40 semi synthetic is a good option which can be used in most vehicles. A complete change with filter would be better than a top up. Then you know it's fresh oil in there and when to change it next time. Changing the coolant wouldn't be a bad idea also if you don't know when it was last done.
-
Dont worry, let the bells be quiet. Every car will consume oil. Be sure to check levels when motor is warm, and stood still for few minutes. Remember to park car with good levell. Same with coolant. There is big volume difference with cold liquids, and warm liquids.
-
I checked again this morning and the oil level was between min&max. Took virtually the shole 1 litre of oil I bought.
The car was on a slope first time I checked yesterday so my initial thought was that was why. So I started it up and reversed it further up my drive to where it levels out. Left it a hour and came back, the oil was at the very tip of the dip stick!!I'll get both oil filter and air filter plus some good quality oil for this coming weekend.
I shouldn't say this but I didn't think to check the oil when we bought it
the guy was so genuine and the car so clean and pulled away easily on the test drive with 3 adults and my son in.
As I say it's only done 38k since 2002, the mileage seems correct as I cross referenced it online with MOT records.There was nothing whatsoever to give me cause for concern when we initially viewed it - it is what it is.....an old small car.
Anyway, time will tell as they say.

-
With that kind of mileage you shouldn't have any major issues anytime soon

I don't wanna scare you or anything but be sure to change the oil and filter at least every 10,000km or every 6 months if not using it that much. I only say this as I have had to rebuild 3 low mileage motors in the past few months due to sludge build up from lack of oil changes. -
More advice needed...
Should I flush first.
I've read that its a very bad idea. I'm beginning to think "Little Suzy" has missed most of her services. So, I plan to try and get her tip top.My plan was on Friday after work - 11am, go the (very) long way home, drain the oil and refill with cheapest oil I can get then go for another drive, return home, drain that, replace the oil filter and refill with good quality semi synthetic 10w30...Any recommendations?
Also change the air filter too.Does that sound OK?
-
I would rather change oil and filter now, drive 2-3 thousand km. And then change again. Use same good guality oil. Ther will allways be left some of old oil.
Even better would be to change oil and filter, drive 2-3 thousand, take oil bottom off, wash it and change oil ring and filte, put in new oil. No old oil left in engine.
-
@Crow said:
I would rather change oil and filter now, drive 2-3 thousand km. And then change again. Use same good guality oil. Ther will allways be left some of old oil.
[b]
Even better would be to change oil and filter, drive 2-3 thousand, take oil bottom off, wash it and change oil ring and filte, put in new oil. No old oil left in engine.You mean take off sump?
I did consider that, but I can't find a workshop manual for the car. Do you have to replace the sump gasket? And how would I find the torque setting for the sump bolts?What's an "oil ring"? Is it the copper washer on the sump plug?
-
No. The oil filter and seal.
BTW, if you added 10w30 you would be fine. In this modern age, oils are compatible with other oils (synth and dino). Adding 10w30 to 10w40 will not cause a problem. 10w30 to 5w30 will not cause a problem.
The rules are:
Dirty oil is better than no oil
Clean oil is better than dirty oil
Clean oil of the right viscosity is better than clean of the wrong viscosity.Apply as needed.
-
I would rather change oil and filter now, drive 2-3 thousand km. And then change again. Use same good guality oil. Ther will allways be left some of old oil.
[b]
Even better would be to change oil and filter, drive 2-3 thousand, take oil bottom off, wash it and change oil ring and filte, put in new oil. No old oil left in engine.You mean take off sump?
I did consider that, but I can't find a workshop manual for the car. Do you have to replace the sump gasket? And how would I find the torque setting for the sump bolts?What's an "oil ring"? Is it the copper washer on the sump plug?
Sorry for my bad english. Translators will not allwas give best translations.
Yes. Oil sump. And by oil ring i mean oil seal that goes around oil sump. You should change that copper ring after every oil change.
You could download "autodata" program, that program shows every work step, and gives all torgue settings.
-
Hi Tosh, congrats on the new ride. I think it needs a half liter of WD-40 and then have them top off the blinker fluid!
I'm sorry. I just couldn't resist. I know nothing about cars except how to drive the wheels off of them. It sounds like you're getting good advice here.
Cheers,
Stew...
-
Stew don't forget to grease the Muffler Bearings^^^
-
@NKlamerus said:
Stew don't forget to grease the Muffler Bearings^^^That's right. And make sure the tires are round. Also change the air in them. Not the pressure, just the air...

Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
