How sharp is sharp for your multitool?
-
If you're sharpening once a week and not actually damaging the blade between sharpenings, I would suggest you purchase a strop and use it regularly. Most of the time when you sharpen a blade, it doesn't need to have metal removed. Most of the time the "rolled" edge just needs to be straightened back out. This is what a strop is for. If you strop regularly, you should only need to use stones to remove metal if the edge is nicked or otherwise damaged.
If you're sharpening once a week and not actually damaging the blade between sharpenings, I would suggest you purchase a strop and use it regularly. Most of the time when you sharpen a blade, it doesn't need to have metal removed. Most of the time the "rolled" edge just needs to be straightened back out. This is what a strop is for. If you strop regularly, you should only need to use stones to remove metal if the edge is nicked or otherwise damaged.
Right on the money = no need to go buy s strop , I use an old leather belt that is attached to the metal leg of my sharpener setup.
I have been using a leather belt to strop with since the beginning of the year. Make sure the belt really is leather, make sure it is smooth and nick free,
You may want to take a glass bottle filled with warm water and smooth it out. then go over the belt with a pumice stone. It will help if the belt is 2 inches or wider.
http://www.straightrazorplace.com/forums/newbies-corner/18839-temp-leather-belt-strop.htmlAnybody have a strop picture? Using leather belt do you have to be awhere of the angle?
About one minute in mate :) http://www.youtube.com/watch?v=0a2Jm3pkXqk
-
I try and keep all my knives razor sharp. I cut the piss out of my hand with a dull knife when I was 15. I still have an ugly scar there.
-
In actually only use a course dmt stone on my blade. I carry another knife allways and I use the MT blade for rough cutting so I dont bugger up the nicer blade.
-
@ducktapehero said:
I try and keep all my knives razor sharp. I cut the piss out of my hand with a dull knife when I was 15. I still have an ugly scar there.I had a guy come at me one night on the docks with a dull knife and it left an ugly scar, but no as bad as the scars he had when he "fell down" a couple times !
-
I try and keep all my knives razor sharp. I cut the piss out of my hand with a dull knife when I was 15. I still have an ugly scar there.
but no as bad as the scars he had when he "fell down" a couple times !
Good to hear

-
I try and keep all my knives razor sharp. I cut the piss out of my hand with a dull knife when I was 15. I still have an ugly scar there.
I had a guy come at me one night on the docks with a dull knife and it left an ugly scar, but no as bad as the scars he had when he "fell down" a couple times !
I have to agree, dull knives makes ugly scar, but impact scars makes uglier scars >:D
-
Not another sharpening thread.
If you're really hard core about sharpening get a 20x illuminated stereo microscope like I have. It's great for examing that perfect edge. -
I always keep my knives in tip top shape. I can't stand dull knives! :ahhh
-
Remember in how sharp is sharp there are many kinds of sharp for different purposes, polished edges vs. saw edges. There are many kinds of bevels for different purposes. While I did get a stereo microscope for other purposes I have found it is really great for examining edges.
-
could you sharper knives using glass? Like the ones on soda bottles?
-
@duckman1975 said:
could you sharper knives using glass? Like the ones on soda bottles?Yes but not with great results . The rounded ( arised ) edges of a car side window are quite good at straightening an edge like a steel would do .
Dunc
-
Thanks, its the only smooth thing available in the field sometimes.
-
@micky d said:
snip
Anybody have a strop picture? Using leather belt do you have to be awhere of the angle?About one minute in mate :) http://www.youtube.com/watch?v=0a2Jm3pkXqk
This also shows the best way to sharpen a knife blade- a stone. There are stacks of sites on the web that show you how and once you have the idea even under the most extreme conditions you can find a flat stone to tone up a knife blade. Like the concrete wall/slab some one mentioned before. Use Sharp Makers and other kits by all means but stones are cheap enough so at least get an idea of how to use the basic and oldest sharpening tool. The satisfaction alone is worth it.
When sharpening it is critical to keep the angle right for the job the knife will be used for. It is worth getting a kiddies protractor just to note what the angle shape is.
I seem to remember there are 2 forms uses stropping with a leather, the use we need were we are just removing the bur as on that video shows the back of a belt will do. The propper stropping is done with jewelers rouge (I believe the red stuff is what they use) on one side and the other side left plain. Used by folks that use folding razors, the rouge side to sharpen the other to again remove the bur.
Talking of rouge, I bought a Benchmade Rescue Hook-
http://www.heinnie.com/cg6ch4645031/Knives/Benchmade/Benchmade-Rescue-Hook/p-92-111-625/
and in the instructions it sugested to use a cotton pajama cord coated with rouge to polish the hook to keep it sharp. Since then I have used that idea for sharpening serrated edges useing strands of wool about a foot long. I use enough strands to fill the slot, wet the strands put on some rouge and pollish up that size slot throughout the blade working it into the pointy bit, I then add or remove strands for the other size groove and repeat. You do not need to do it as often as you do keeping a flat blade sharp but it is a lot easier than using a ceramic rod that never quite fits.Dave
-
they are as sharp as I can get them with those carbide hand sharpeners.
-
Jewlers rouge is a bit too fine usually. There are many good polishing compounds out there. I prefer something called Yellowstone which is actually pink. They are usually made of various oxides. It seems there are state secrets about what some of these have in them. Some use waxy compounds to mix with the abrasive. They are excellent for putting that sharp polished razor edge on. They can be rubbed into a flat piece of leather or some material like denim. This is the way to go for a polished edge as opposed to a saw edge. A saw edge is better for cutting things like cord and rope. After many strops with polishing compound a bevel will begin to round and has to be reshaped some. The finest grit sharpening stone I have is a 2200 grit ceramic. You can get stones up to 8000 grit but they are expensive and stropping with a polishing compound is more economical and does the trick.
-
All mine will shave hair. An I carry touch up gear in my briefcase.
Chris
-
A little off topic, as everyone knows if you use your knife very often and on many unrecommended ways you will see scratches on the surface of the knife. I use a metal polish to remove them and bring back that shinney surface, are there a better way to do it?
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login