Double (large) blade Victorinox Compact
-
<u></u>
@tattoosteve99 said:
You could do what Syph did on one of his and reposition the philips?Wow, Syph has done so much stuff, I'm not sure I remember. I recall seeing one with both cork screw and phillips located on opposite sides.
I would be OK with just replacing the cork screw with a phillips. I'm just wondering what I might do considering I'm using a second main blade back spring and have an opportunity to install some kind of additional back side tool. What else would work well in a main blade back side tool that is only one layer wide? It would have to match the width of the back spring.
-
Bob (Syph) overcame the problem of getting the Phillips to fit by milling it down a bit, I added an extra spacer insted (which helped with other issues too). As to adding an alternate tool instead of the Phillips, all the other back tools will be thinner, so it's just a matter of adding the right thickness washers
-
@50ft-trad, @tattoosteve99
Found Syph's post on the phillips mod. It a little too much than I can handle doing without a mill. Nice idea though.
/post/1145625
-
I like your original plan. Cut the hook and use the base to tension the scissors, cut the liner to allow the phillips. And take lots of pics.

-
@zoidberg said:
I like your original plan. Cut the hook and use the base to tension the scissors, cut the liner to allow the phillips. And take lots of pics.
Your right. I'm going to have to cut the hook or make some kind of spacer to keep the tension.
I would have eventually realized that, probably on assembly. :D -
I've done it several times on 84s using the blind backspring from the Recruit. I usually put a wood saw in between.
I've done it on Wengers as well...but using the tang of the corkscrew for a spacer...




-
I did a "Double Recruit" mod a while back, i also have a genuine a Wenger "Double Blade".

-
Here's the link for the one I did....
/post/1144091
-
I recall doing a trial assembly on a 91 that incorporated corkscrew and Phillips un-modified. Added extra liners (I think 3) to create space for the offset of the Phillips. Never went through with it...but the plan was to make a thick one-piece liner for final assembly.
-
Found pics...



-
I also thought that the thick spacer might provide the opportunity to add slots for pull-out tools...like a diamond needle file for sharpening.
-
Found this one where Syph thinned down the phillips so it's kind of like the Leatherman bit driver phillips:

Could be an interesting alternative.
-
This is the one I was referring too

Again Syph ;)
/topic/34772
-
I would like to do something like that, but I'd rather stick with standard scales and not make this too complicated.
-
-
@Spork, Lord of Lime Jello! said:
Found pics...
I like this idea.
Simple yet gives you the ability to use standard scales on it.I'm always about simple mods that can be done with basic tools...partly because I don't have access to machine tools. Another thought about the spacer is to sandwich some fiber material between two liners to match the color of the scales.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login