firearms
-
I have a copy of "Cartridges of the World" on my Ipad.
This is what it says about the .327 Federal Magnum.
Introduced in 2008, the .327 Federal Magnum is an attempt to improve the performance of the .32H&R Magnum. .32H&R factory ammunition, as per SAAMI specs, is not loaded to the cartridge's full potential. This is due to the weaker H&R revolvers chambered for this cartridge. Cartridge performance for the .32 H&R Magnum can be subsequently improved with hand-loads, when fired in Ruger or S&W revolvers. The .327 Federal Magnum takes this performance to a new level. This was accomplished by increasing the case capacity and loading the cartridge to a substantially higher pressure (45 000 psi) than the .32 H&R Magnum which is 21 000 psi. In fact, the .327 Federal Magnum is loaded to a higher pressure than any other commercially loaded defensive handgun cartridge. Since .327 Federal Magnums cannot be chambered in any other .32 caliber revolver, there is no concern of over-pressure issues. Ruger worked with Federal during the development of this cartridge and initially offered a three inch version of its SP 101 six shot revolver in this chambering. With factory load, a 100-grain bullet will leave the barrel of the SP 101 at about 1400 fps.
The .327 Federal Magnum is a handful in a 28 ounce SP 101 with full power loads. Federal does offer an 85 grain, low recoil load that is much more controllable, but it is still markedly more powerful than any factory .32 H&R Magnum loads. The terminal performance of this cartridge with both the 100 and 115 grain Speer Gold Dot loads approaches that of the .357 Magnum with similar bullets. Penetration in 10% gelatin is in excess of 14 inches, and bullets exhibit wide expansion. The design of these two Gold Dot bullets is very important to this cartridge, because prior to them, there were no .312 diameter bullets that could withstand the velocity this cartridge is capable of producing.
If you can manage the recoil from a handgun, it is a viable self defense option, and from a rifle, it is capable of taking deer sized game out to 100 yards. From the 16 inch barreled Marlin, the 110 grain bullet speeds along at over 2000 fps. One thing that sets the .327 Federal Magnum apart from all other revolver cartridges is the fact that any revolver so chambered will also fire .32 Short, .32 Long, and .32 H&R Magnum ammunition. This cartridge's versatility is unmatched.
-
@Humppa said:
Gonna go to the range tomorrow! :)I will shoot a great gun, it´s not mine, but my shooting club owns several of these. It is an Anschütz Modell 54 in .22lr. A single shot rifle.
One of the most precise systems I´ve ever shot.
I'm the fortunate owner of five Anschutz rifles.I posted a pic of one my sporters in a thread titled ".22 rifles" last year.
All of the Anschutz rifle are shipped with a target which is shot at the factory.This rifle had a target that consisted of 10 rounds fired at 50 meters and all shots were touching and also fit inside of the head of the figure on a dime.
Here is my Anschutz 54.18 Silhouette rifle.

-
Here is a pic of the Anschutz 54 Sporter.

-
@captain spaulding said:
Browsing some random links on youtube I came across a round I'd never heard of before; the .327 Federal Magnum. Anyone have any experience with this one?
No personal experience, but the round has been around for years. Around 5 or so if I remember correctly.

It is "thinner" than a .357 mag, but is supposed to create the same amount of energy while allowing a revolver cylinder to hold 6 shots instead of 5 shots of .357 mag.
Should be a great round. I personally like to stick with common rounds as ammo is already expensive as it is and specialty rounds are normally more expensive and harder to find.
+1 Knew a man some years back who went on African safari with two rifles, one a 30-06 and the other a new super magnum. The guns made it okay, but the ammo didn't. Turned out there wasn't a round of the new cartridge to be had in the country he was in. The 06 wasn't a problem, a fact which saved the trip.
-
Here is a pic of the Anschutz 54 Sporter.
Anschutz are always nice.

Nice?
Understatement of the year if you ask me.
-
[quote author=SAK Guy link=topic=53984.msg1212189#msg1212189 date=1452957194]
I like both but shoot a 1911 much better.Here's an unrelated ammo test pic of the Kit Gun just because....
The S&W 650 is one of my favorite fishing guns,shot shells for snakes,and hollow points for rabid animals,and I modded some mag shell cases to shot CB longs in it also.
-
I like both but shoot a 1911 much better.
Here's an unrelated ammo test pic of the Kit Gun just because....
The S&W 650 is one of my favorite fishing guns,shot shells for snakes,and hollow points for rabid animals,and I modded some mag shell cases to shot CB longs in it also.

Cool!! Great versatility all in one cylinder and boy, aren't those 22Mag shotshells big medicine on snakes! 
-
Went out today for a fun shoot. I am really liking the revolver. I do need a holster for it however, and still the local gun shop is having a hard time getting me one. I know that most American businesses could care less about selling to Canada...not enough population, probably have to jump through flaming hoops, etc...but it sure does make my life difficult. I do have an old PPC holster that came with the revolver, but the trigger is not covered. I was allowed to use it today but I wouldn't be able to in an official IPSC match. Either I find something soon, or I am forced to modify this one that I have...and I would hate doing that.
On the positive side, I think I am turning into a revolver guy. Speed loading the chamber wasn't difficult at all, and almost as quick as slapping a magazine into a semi auto. For my first outing with it, I am hooked.
-
@Chako said:
Went out today for a fun shoot. I am really liking the revolver. I do need a holster for it however, and still the local gun shop is having a hard time getting me one. I know that most American businesses could care less about selling to Canada...not enough population, probably have to jump through flaming hoops, etc...but it sure does make my life difficult. I do have an old PPC holster that came with the revolver, but the trigger is not covered. I was allowed to use it today but I wouldn't be able to in an official IPSC match. Either I find something soon, or I am forced to modify this one that I have...and I would hate doing that.On the positive side, I think I am turning into a revolver guy. Speed loading the chamber wasn't difficult at all, and almost as quick as slapping a magazine into a semi auto. For my first outing with it, I am hooked.
Is it against the law for me to buy one and send it to you?
I know how Canada is just one revolver holster from invading the US and all that.
-
Went out today for a fun shoot. I am really liking the revolver. I do need a holster for it however, and still the local gun shop is having a hard time getting me one. I know that most American businesses could care less about selling to Canada...not enough population, probably have to jump through flaming hoops, etc...but it sure does make my life difficult. I do have an old PPC holster that came with the revolver, but the trigger is not covered. I was allowed to use it today but I wouldn't be able to in an official IPSC match. Either I find something soon, or I am forced to modify this one that I have...and I would hate doing that.
On the positive side, I think I am turning into a revolver guy. Speed loading the chamber wasn't difficult at all, and almost as quick as slapping a magazine into a semi auto. For my first outing with it, I am hooked.
Is it against the law for me to buy one and send it to you?
I know how Canada is just one revolver holster from invading the US and all that.
I couldn't see how a holster would be illegal to send to Canada, but stranger things have happened.

-
Thanks for the offer, and I may just take you up on that. Going to give the local shop their time however.
-
@Chako said:
Thanks for the offer, and I may just take you up on that. Going to give the local shop their time however.K.
I also would like to add if your revolver reload is almost as fast as your semi reload you are reloading your semi wrong.
Well either that or you are much better at this stuff then I am. Which is entirely possible.
-
No. Just a rank beginner. I came in last yesterday...but in it for the fun.
-
@Chako said:
No. Just a rank beginner. I came in last yesterday...but in it for the fun.That's how I am also.
Often lose because I place to much emphasis on hitting and not enough on speed.
Something about shooting sports make it so that I do not care so much about where I place as much as improving my skills and just having fun.
-
I hear you. My club consist of a lot of older guys who have been doing this for decades. Very few younger guys like me. I harbour no illusions about beating them...but I do try to improve every time I go out. I was last, but I was also the only guy with a revolver. They are slower to load and hold less rounds...so no surprise I was the tail end charlie. :D
On the other hand, a lot of the older guys are thinking about those revolvers they used to shoot back in the day and still have in their safe somewhere. Maybe my shooting something different might even the playing field somewhat by seeing more revolvers show up on the scene. If nothing else, it was a great conversation starter.

-
@Chako said:
On the other hand, a lot of the older guys are thinking about those revolvers they used to shoot back in the day and still have in their safe somewhere. Maybe my shooting something different might even the playing field somewhat by seeing more revolvers show up on the scene. If nothing else, it was a great conversation starter.
Many years ago (still in school) I went to a shooting range with a friend and his parents.
Had fun shooting several firearms, but the one thing I'll never forget was an older guy with his revolver.
They were shooting a 9 targets and had one of those little counter machine thingies........he had to reload, and he was barely slower than the guys shooting autos. 8)
What really got me was everything about the old man was saggy - eyes, clothes, shoulders, belly....you name it!
You would be forgiven for underestimating him all day everyday, but if that revolver comes out running wouldn't help!

-
Dont run.
You will just die tired.
-
By request, my Skunk gun....
-
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
