EDC Experiments
-
Would a pair of electrician scissors work to cover wire cutting needs?
I have considered going with the Crater + bit kit/plier wrench carry combo but I think I would miss wire cutters also.
-
So we just need Knipex to build in a wire cutter into the Cobra.
-
Maybe we could put a couple of those replaceable wire cutter blades on a Cobra? It would have to be on the same side. Or maybe it could be put on just one side that opposed the jaw as an anvil cutter.
-
I'd rather just carry a small dedicated cutter or PS4 in a pocket.
-
Or go back to what I've done the past 8 years - pocket carry a Skeletool for the blade, bit driver, wire cutter and pliers, and then carry a Cobra or Plierench and LM bits in a sheath or bag.
-
Then of course have a Super Champ in the bag to cover all the bases.
-
@ToolJoe said:
Would a pair of electrician scissors work to cover wire cutting needs? ...I want to be able to cut a 3-conductor, 16 gauge AC line cord as well as 12 ga. solid copper wire. Most 4 inch pliers multitools (e.g., Rebar, Spirit, SOG PPP) can do that, but I'm exploring carrying a few individual tools instead of a multitool.
I have electricians scissors. They are good for small gauge telecom wire cuts and weigh about 3 ounces (hefty).
-
I've been looking for a multi bit pocket screwdriver which takes 1/4 inch bits like that Suzo Happ. Thanks for finding it. One point of confusion in the Amazon description is that the driver comes with a 3/8" (not 1/4") nutdriver.
I had noted a similar pocket driver at http://pocketscrewdrivers.com , but it looks like you must buy them in quantities of 150 or more:

-
That's not the one I ordered. It's this one.
-
If I were Leatherman I'd put a LM bit driver on everything they make - maybe even flashlights. It's a way to tie a customer into their ecosystem and make everyone want to have bits and accessories.
-
Never mind, that is what it says - 3/8' driver. Dang! I wasn't paying attention.
-
I'm looking right at it, and those definitely look like 1/4" bits, not 3/8". In fact I don't think I've ever seen 3/8" bits. I found it on two other sites with the same stock description though. I think it's a typo. Those screwdriver heads would have to be massive if they were 3/8".
-
It arrives tomorrow, so I'll tell you what it is then.
-
Forgot I have the bit driver Crater too. No need to carry the bit kit.

-
Great thread, Tom.

-
Thanks!
-
Parnass, I got the bit driver in. It's definitely 1/4". It's quite a bit bigger than the Craftsman driver. Here's a comparison along with the other drivers I got in and a Wave for scale.

-
It does fit into the sheath with the Cobra where the Craftsman driver was.
-
I wish these little drivers had a hex shaft or fitting above the bit or on the end so we could put a wrench on them for more torque.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login