LM Skeletool , my thoughts
-
Nice words and great pictures Dunc! 8)
Saaaaaay, since when are Leathermans and Vics allowed to intermingle in the same photo? >:( :D

-
Thanks for the kind words everyone :)
Heres a little update as I have been back from my hols for about two weeks now . I've just taken two photos of the raised blade stop on the lock bar so you can see just how much its worn down . Theres no sand or grit to help it and its oiled too . I had to slightly tighten the blade so its kept retained .


Dunc
-
There's been a few comments about the blade stops on both this and the CX version hasn't there?
It doesn't seem to be all of them (I've handled maybe 10 of these from new, and none had a problem), so I wonder if it's a quality issue, rather than a design flaw. It's well documented how they struggled to keep up with demand after release, so maybe the usual QC was skipped a bit. Shame really.
I think I recall someone saying that they had seen a prototype that used a ball-bearing for this - I wonder if that worked better, and whether it was ditched for cost?
-
Great review

I noticed the detent starting to wear down on my CX...the blade opens and closes pretty smoothly now when at first it was horribly tough.
Can't wait to hear what you did to keep the spare bit in place...mine doesn't fall out, but even a short drop onto a carpeted floor sends the bit flying :-\
EDIT:
Some ideas I had were wrap a thin layer of tape around the bit, or slightly bend in the opening of the compartment where it goes.. -
Nice pics and review Dunc. :)
But that detent sure doesn't look right, does it. :-\
-
Nice review and pics, Dunc
I'm waiting for my skeletool cx to arrive so i can try it for my main EDC tool. I'm using a Kick now mainly because I like the light weight and pocket clip. I'm hoping the skeletool will suit me better as it has all the tools the Kick has but is thinner and lighter still. And has a much better knife. I've been hearing a lot of complaints that the spare bit keeps falling out so I'm a little worried....
-
Great review and pictures matey :)
Still don't want one though :P :D
-
@Micky d said:
Great review and pictures matey :)Still don't want one though :P :D
Holding out for the Freestyle are you Mike? :D
-
-
One thing I have noticed is that although the blade stop has worn down is getting alot smoother so perhaps it will settle down at a certain point . Remember we can always send them back for repair .
If your worried about the spare bit holder being loose I will start writing a thread about it now :) and will post it in the LM forum . Give me half an hour or so ;)
Dunc
-
Nice job Dunc

-
Ooo, Dunc is in love.
I'm a bit surprised to hear you rave on the fit and finish.
Would you think it is Blade-centric enough to replace a dedicated folder in someone's kit?
-
@Nomad said:
Ooo, Dunc is in love.I'm a bit surprised to hear you rave on the fit and finish.
Would you think it is Blade-centric enough to replace a dedicated folder in someone's kit?
Depends if that person carries a Sebenza or not :P
But seriously I have EDC'd it and its fine but its not my first choice being honest . I always have a knife and a multitool . I will never just carry one , simply because if it got lost then you would have nothing or if one blade gets blunt you still have another .
Dunc
-
Depends if that person carries a Sebenza or not Tongue
But seriously I have EDC'd it and its fine but its not my first choice being honest . I always have a knife and a multitool . I will never just carry one , simply because if it got lost then you would have nothing or if one blade gets blunt you still have another .
Where's the squinty smiley...
So if you had your trusty Supertool on you, would you consider having the Skeletool as your folder?
Maybe I should just buy one :D
-
Depends if that person carries a Sebenza or not Tongue
But seriously I have EDC'd it and its fine but its not my first choice being honest . I always have a knife and a multitool . I will never just carry one , simply because if it got lost then you would have nothing or if one blade gets blunt you still have another .
Where's the squinty smiley...
So if you had your trusty Supertool on you, would you consider having the Skeletool as your folder?
Maybe I should just buy one :D
No , If I had my Supertool on me then I wouldnt have the Skeletool but I would have a Seperate folder .
Yes get one , if you dont you will always wonder about them .Its for someone who wants to carry light , just the basics in one tool . Although I like the tool I cant see it getting too much EDC as I carry loads and the weight doesnt bother me .
dunc
Dunc
-
Yes get one
Before or after I get a Spirit? ???
-
After, like me! I just bought mine for $38. =D
-
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login