Cleaning your tools. Tips & tricks.
-
Thanks everyone for the personal experiences and in depth descriptions. As straight forward as it seems it's good to have a heads and has helped me (and others I'd assume).
look, works so well 
-
This is my method for used knives, tools, and multitools I get. Cleaning is a little less extreme.
If I can't get the blades open--hose the thing down in WD-40 and let it set about 4 hours at least.
Then, rust is removed with an SOS pad and WD-40 as a cutting fluid. Usually, the SOS pad is already well used and devoid of its soap.
The whole thing is scrubbed with extra strength dish detergent and warm water. I use Victorinox's care tip when the blades are grimy around the pivots--opening and shutting it repetitively in the soap and water.
Then, I dry it, oil it with baby oil and a small dropper I found in some of my stuff a while back. I wipe high carbon stainless and carbon steel blades with oil to prevent it rusting. Then, I either put it away or slip it in my pocket.
-
baahh, when mine gets dirty i just toss it in the garbage and buy a new one. ::) ::) ::)
I'm with Capt. on cleaning methods.
If something is super rusty i use a vinegar soak then start to work with the elbow grease.
-
Rust remover I use molasses. Works brilliantly.
-
I use the hosmurfer/soap method then brush and lubricate however have never had to clean a tool with a BO surface. Is the BO susceptible to any lubricants or cleaning fluids or is it ok to do the same to them as a stainless surface.
Thanks,
John.
-
OK I can't decipher hosmurfer ???
:D
-
Good thread guys
I admit I don't clean my tools as I should
Sometimes they get oiled though :D -
hosmurfer!

-
Hot water is correct. Don't know where the hosmurfer came from.
Anyway I am wondering if one needs to take special care with a BO finish.
Thanks. John
-
I dont. I clean it the same way as everything else.
-
New page banana man dance

-
@jcs0001 said:
Hot water is correct. Don't know where the hosmurfer came from.Anyway I am wondering if one needs to take special care with a BO finish.
Thanks. John
It's a naughty word filter John - basically it automatically replaces the "naughty" word with "smurf" - can be quite amusing sometimes.
Re cleaning the BO - I'd say that BO finishes vary a lot and some seem to be more robust than others! Warm / hot water shouldn't do any damage, but maybe lightly wipe rather than scrub with a toothbrush.
-
Dave
Between the forum "correcting" things and my ipad mini (when I use it) doing the same, it's a wonder that my messages make any sense at all :D
Thanks for the info on the BO finish. Will have to experiment in a "gentle" fashion.
John.
-
Just to make sure. Is rubbing alcohol chemically ok to clean sticky packing tape residue off a blade?
-
Yes it is, olive oil works great as well.
-
Sometimes you have to let it sit on there for a bit but it should dissolve the residue.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
