Favorite SAK/multitool combos
-
@theonew said:
Mine was completely dull as well and also the bevel that was ground in varied over the length of the blade, starting at around 40 degrees for the first third and then tapering down to about 30. The variable bevel didn't really bother me as I've done that with blades intentionally to keep a sturdier edge near the area where the most force can be applied but I've found using a round rod sharpener to be the best way to sharpen it since it is easier to follow the "curve".But to be honest I will slowly over time turn this into a regular v-bevel and have already started sharpening the other side. If you want to quickly put an edge on the blade and don't mind transitioning to a v-bevel start sharpening the flat side by holding it up a few degrees so that you are only contacting a small area of the bevel. You should be able to get it serviceably sharp in a very short amount of time this way. Hope that helps.
Okay, I'll probably give that a go, would prefer a regular v-bevel - I have a Spyderco Sharpmaker, so would prefer to just have a 40 degree angle on a v-bevel all round
-
Again today:


-
Ultra heavy + ultra light

-
Where's the SAK, Poncho?
-
Poor Poncho is out of practice after vacation

-
Whatever do you guys mean


-
:P
-
-
-
Like that OHT + Pioneer X!
Have to try it out too!
I decided to go with Wave+111mm.
Similar tools, but these Vic phillips and Wave pliers are what I needed at the same time...

-
Wenger ST14 and Purple Skeletool today

-
Since stopping work I've been able to move towards sheath carry. The beauty about this sheath, other than it being a perfect fit for these two tools, is that can put it on and take it off withouth removing the belt. I hate the look of sheath carry to be honest. It's fine for emergency services and military, but to me it just looks too "wannabe" otherwise - just my personal opinion
- and I can unclip this and stuff it in a jacket pocket when leaving the house.It's also be best solution I've found so far, for carrying these two tools without them getting too scratched up. The Climber Small and Juice KF4 - an excellent combo with minimal duplication.
Only one can opener, bottle opener, Phillips..... the stuff that so often gets duplicated between SAK and pliers tool. Yet between the two I'm not left wanting for anything either. I wouldn't always carry the same light, but this is one of my favourite pocket lights anyway.
-
@50ft-trad said:
I hate the look of sheath carry to be honest. It's fine for emergency services and military, but to me it just looks too "wannabe" otherwise - just my personal opinion
- and I can unclip this and stuff it in a jacket pocket when leaving the house.I feel exactly the same way, but I'm OK if the sheath is slim enough to not be obvious. I'm not sure what I'm "wanting to be" though when I do carry them.
A dork, maybe?The stainless clips are pretty much a requirement for me so it can be removed without the belt.. I like your setup.

Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login





