And so it begins.... (My adventures into Alox!)
-
@Syph007 said:
Waterjet finish is pretty rough ya and it also doesnt make perfectly perpendicular to the surface cuts. Not ideal for very thin components. Also I can work on a cutting strategy to keep supports in place on the outside while I cut the inside and tips, then cut the outsides last and leave little tabs. Only the very inside part will need the 1/32 bit the rest will be cut with the 1/16. I finished the Gcode so I can try it tomorrow.
Good luck!!!

-
First cuts went just fine... Now does it work?

-
+1

JR -

+1

JR


-
The suspense is killing me :ahhh :ahhh :ahhh

-
Me too! :ahhh

-
Syph,
Seeing the springy nature of the tweezers you're now working on reminds me that quite a while back, you were making liner locks for some 93mm mods you were doing at the time. Any chance that idea could translate to the 91mm mods you're doing?
Sent from my iPhone using Tapatalk
-
Well???

-
So how long before you start making your sak-s completely from the ground up? :D
-
The leaves of the tweezers were too thin. Machined fine though but I got a better idea on how to cut them and not need a tiny 1/32 bit.
-

[Intensity intensifies] -
:ahhh
-
Does it involve a horizontal milling machine?
-
-
At least you realized that, it didn't even occured to me! My thought process was more in the lines that a horrizontal mill will have more support, you could cut a long groove (like an Al extrusion, think the side profile of the tweezers) and than just cut them off. Good solution you've found, I hope it works well.
-
Ive FINALLY come up with a way I like to hold all the scale tools people want. Drawing it up now in CAD then I can post what Im thinking of trying. The pen is still too thick to fit unless I can find an option for a thinner one, but regardless if this works I can fit ...
Toothpick
Tweezers
Small firesteel
Pin
Sewing needle and threadThat takes care of what most people would want, and there will be a small space left over to store whatever else could be jammed in there.
Ive been stuck forever trying to work out the mechanism. I know I could machine a little drawer hollow that opened in the scale, but how would it lock into place to avoid accidentally opening, and it would also have to be simple so that machining time/cost wasnt too much more and no extra parts like more screws and tapping would be needed.
I did have to go with much thicker Ti for the backscale 0.155" instead of the 0.100" I used now, but that at least this will provide a way to offer people what they want. It would still be slightly thinner than a stock SAK with plastic scales though (0.070" thinner) since it still wont have the outer liners. So still an ok compromise I think for those that would want this.
My breakthrough in mentally working on this was realizing how I could machine the drawer to have a built in retension spring to snap it home and become a solid part of the scale when not needed. A small nail nick would be exposed either on top on inside to pop it open. It would be part of the back scale and open upwards like a normal tool, but the hinge point would be towards the inside not where the normal tools pivot.
-
Oh that sounds interesting Syph

Proud SAKMC member :)
-
-


--> [ ]
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login

